2. amps-preamps
  3. 1137965724

CD output voltage too high for preamp: what to do?

I have an Audible Illusions preamp which is designed for a 1.5v input signal. I am told that this is standard. My Ayre CX-7e puts out 2.25v. They play beautifully together but I have too little control over volume: I cannot use the preamp vol controls beyond 9 o'clock because it is way too loud. Likewise it is hard to get just the right volume in the limited range available. This is worse with some CDs for reasons I do not know.
Audible Illusions will change the preamp attenuation board for $275, but before I do so I wonder how others have dealt with the problem of newer CD players with higher outputs than their preamps were designed for.
gmargo
swampwalker's avatar
swampwalker
5,138 posts
 
Your only other option is to use an in-line attenuator between the cd and pre. They come in various values and are modest in costs. You can try an inexpensive set from Parts Connexion and then if it works out, get a more expensive set like the Rothwells.
simon74
216 posts
 
Hi there,
a set of Rothwell attenuators will solve your problem.
I think these can be had in differnt values and cost about £35 over here - sure I've seen them advertised on Gon.
Russ Andrews (the Kimber distributor in the UK) does attenuated i/c's for this very reason, not sure if Kimber do likewise.
Rgds Si
Post removed 
kr4's avatar
kr4
3,680 posts
 
BTW, 2V (at 0dB level) is the output standard for CD players although, as you already know, it is often ignored. In crude A/B tests, the louder player will always sound more impressive.

That said, another major factor in your problem is the input sensitivity of the power amp which may be a bit high as well. After all, 2.25V is only 6dB more than 1.5 and should be within the ambit of the volume adjustment.

Kal
More to discover