300B SET Tube Amp recommendations anyone??

Singled Ended 300B PowerAmp are common in many manufacturers with excellent performance. outputpower
12-15 watts usually.

Push-pull 300B's numerous Manufactgurers had failure
as theirs usually loose the vocal clarity and sweetness
as single end items ( more easily built, I supposed).

I had searched for years, whilst still using single-ended
until I met Canary Auidio, CA303 signature ed., (they have the new CA330 now,) if you upgrade the rectifier tubes, 6SN7's etc.
performance will be even further amazingly good.

Their Dual Mono Block Tube_PRE-amp's are very good too.
Mono-Block's plus separate L/R Power supplies in 4
chassis /set. place 1 x nice 12AX7 on each side instaed of
factory-supplied "sovltek". you will not be disappointed.

Dpang233 is mistaken.

Very few 300 SET output 12-15 WPC.

7 to 8 WPC is far more common.

Dogpile,

I have the Triode M300Se monos and can attest to them being both beautiful sounding and looking. They are driving Micropure Kotaros (4 Ohms - 84 dB/1M in a small room) and have plenty of power and a wonderful balanced tone. There's never a shortage of "I never heard that before" moments with performers regularly stopping by only a few feet in front of me.

They'll be staying put for a long, long time - highly recommended.

Cheers,
Garry

Dogpile,

They are driving Micropure Kotaros (4 Ohms - 84 dB/1M in a small room)

** Slight correction - the Kotaros mentioned above are 86 dB @ 1M.

Cheers,
Garry

Dogpile:

Audiofeil is right. Common 300B SET output is 7-8 watts. I wouldn't advise driving 92dB full-range speakers with a 300B SET amp, because you're gonna' clip and destroy the drivers eventually.