I have Maggie MG 1.6's - need amp advice

Maggies are easy to drive up to the 'knee' of their magnet system which is not push-pull (MG 20.1s are an exception and are easy to drive at any volume). Getting additional volume above the knee requires a lot of power as the speaker dynamically compresses. This has to do with the distance that the diaphragm gets from the magnets during excursion- the strength of the magnet decreases by the square of the distance. Getting bass off of the diaphragm helps a lot too as that effectively limits excursion, allowing 'below the knee' operation as some fairly high sound pressures.

Below the knee, they are easy. A set of our M-60s will do quite well if used with a set of ZEROs. The trick with using any tube amp is an effective 3-4 ohm capability, which is a stretch for many tube amps. A set of ZEROs solves that nicely.

Atmasphere...With a one-sided magnet, the field would get stronger in one direction and weaker in the other. I would therefore expect the speaker efficiency to change little with increased excursion, but with distortion increasing.
Do you have any solid info regarding the field spatial distribution? The diaphragm excurion is so small that I question how much field variation actually exists (as opposed to theory). I have always believed that getting the very low frequencies out of the woofer is helpful for cone drivers, but you point out that for Maggies it may be even more important.

Dear Atmasphere,
Could you write a word or two about what you mean by "The trick with any tube amp is an effective 3-4 ohm capability...". Thanks.

This was my solution to finally getting my Maggies to "come alive" and it worked wonders. The Innersound is frequently available used for about $1500. It delivers about 600wpc into 4 ohms.

More recently, I've ended up bi-amping mine, with a tube amp on the mid/tweeter panel and the Innersound on the bass panel. Best sound I've ever had from them in 7 years of ownership, and a lot of different amps tried.

Bi-amping greatly increases the power the amps are able to deliver to the drivers. The internal crossover is bypassed, and a line-level crossover is inserted between the preamp and the pair of stereo amps (or 4 monoblocks or whatever). My first bi-amp was using 2 stereo tube amps on the Maggies, and that produced much more satisfaction than my old Classe CA-200 despite having less power per channel.

YMMV. Hope this helps. Be glad to share details if you're interested.

dfhaleycko

When you say a line level crossover is inserted btwn the preamp and pair of amps. What do you mean by this. do you need to buy an external xover or is this something the maggies do on their own.