Bill,
While the 3V output of the CDP is quite sufficient, the output impedance is 220 ohms single ended. George may need to weigh in here on how that might affect the matching between CDP and Lightspeed. It should work as typically you want a ratio greater thant 10:1 between the input impedance of the passive preamp and the output impedance of the source. The greater the ratio the better. Same is true for the ratio between the input impedance of the amp to the output impedance of the passive preamp. What complicates matters is that the output impedance of passive preamps vary by volume setting.
The 67k ohm input impedance of the Samson amps is lowish (maybe best to check with Paul on that spec, I'm going by memory here) but workable (under 50k ohm would definitely pose some issues). I prefer at least 100k ohm. However, I did use a passive preamp with my D-225 for quite some time with no problem whatsoever.
While the 3V output of the CDP is quite sufficient, the output impedance is 220 ohms single ended. George may need to weigh in here on how that might affect the matching between CDP and Lightspeed. It should work as typically you want a ratio greater thant 10:1 between the input impedance of the passive preamp and the output impedance of the source. The greater the ratio the better. Same is true for the ratio between the input impedance of the amp to the output impedance of the passive preamp. What complicates matters is that the output impedance of passive preamps vary by volume setting.
The 67k ohm input impedance of the Samson amps is lowish (maybe best to check with Paul on that spec, I'm going by memory here) but workable (under 50k ohm would definitely pose some issues). I prefer at least 100k ohm. However, I did use a passive preamp with my D-225 for quite some time with no problem whatsoever.