Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
Wasn't one of the active buffer designs posted on the DIY forum a tube version? I recall seeing the one from Nelson Pass as well.
Yes, Nelson Pass very kindly did get involved, and designed a nice direct coupled discrete (no yuk opamps) DIY buffer for the Lightspeed Attenuator, because some of his amps were 12k and 20k input impedance, and this made Lightspeed Attenuator match those low impedance amps correctly.

Cheers George
George, aren't the Burson Audio buffers an FET design that does not use ICs? Their RCA version includes a volume control too. Curious as to why the balanced XLR version doesn't. Might have liked to the balanced XLR version give a spin with my Atma-Sphere amp.
Post removed 
Yes the Burson is also discrete but with +6db of gain, but not DIY, and Nelson's is unity gain and I would say more transparent.
As for running a single ended Lightspeed into a balanced amp, you could use something like these on the input of the Atma-Sphere's

www.jaycar.com.au/productResults.asp?keywords=rca+to+xlr&keyform=KEYWORD&SUBMIT.x=29&SUBMIT.y=7

Cheers George