2. amps-preamps
  3. 1201735953

For people with experience with Class-A amps

Hi All,

I had a question for all you audio folks who have experience with Class-A power amps as I am new to this myself.

This is bugging me so I finally decided to ask - I have a class-A power amp (name will be with-held to protect the innocent) where I notice with no shade of doubt that the right heat-sink is warmer to the touch than the left heat-sink after about 2 hours of play/program material.

I got hold of a thermometer & measured the heat sink temperature (stuck the thermometer probe deep into the heat-sink fins & waited for the temperature read-out to increase/decrease by 0.1 degree Celcius).
What I found was that the right heat-sink was 1.5 - 2 degrees Celcius HIGHER than the left heat-sink. I have about 4 readings so far. Altho' not a lot of data points, each measurement has the identical trend - right heat-sink was 1.5 - 2 degrees Celcius HIGHER than the left heat-sink.

This indicates to me that the right channel current bias is more than the left channel current bias. Am I correct in my thinking?
2ndly, should I be worried about this?
(in that, over time, this temperature differential could diverge & the amp could run away thermally?).
Should I get the dealer to adjust the bias so that both channels are more or less equal?

I realize that "more or less equal" is a fuzzy term. To that effect, in your respective experiences, what should the temperature differential be between the 2 channels? 0.5 degree Celcius? Less? More OK? if more, upto what point OK?

Thanks very much in advance for your help.
128x128bombaywalla
shadorne's avatar
Ag insider logo xs@2x
shadorne
7,467 posts
 
Bombaywalla,

You should try to relax a little - I recommend Rockband - it is great fun through the main system (loud) - not audiophile sound quality of course but hit those drums and you will forget sound quality and just enjoy the music! They even have a song, which I suspect, may be just right for audiophiles such as you - Shirley Manson singing "I Think I'm Paranoid" ;-)
bombaywalla's avatar
bombaywalla OP
1,958 posts
 
Shadorne,

very funny!! ha, ha, ha!! :-)

OK, I get the point.
My inexperience w/ class-A amps "forced" me to ask the audio community at large.
Newbie to class-A cutting his teeth/getting his feet wet. Cut me a little bit of slack, chief!
jsd52756
420 posts
 
"If your amp is true Class A all the way, it will be
hottest at idle."
FYI - I have a Krell FPB300cx and it gets hotter the louder & longer I play it. It is aledged to be "Pure Class A" (key word here; aledged). I can play it at low volume for 10-hours and it stays cooler than being pushed. My point being, I question the above statement.
Good luck in your quest.
-John
elevick
2,636 posts
 
John,
That's the opposite of Class A. Class A amps are so good because they are always running at full power. The power has to go somewhere when not being used for sound, hence the heat. As you play louder, the heat dissipation reduces.
The Krell may sound better than many class A amps but it not. I'd say that Krells are very nice but not as "warm" sounding as Class A amps (pass, threshold, aragon...).
rleff
1,065 posts
 
Were your measurements taken during playback or idle state?
I think I would agree with ralph's response from atmasphere
that there is nothing to worry about; if you notice some audible changes then I would investigate more.
More to discover