Tubes and light weight bass

These speakers were voiced with class A solid state amplification and are capable of amazing bass slam and authority. Suggest ditching your amps and getting an Usher 1.5 amp if you like the speakers. Keep the tube preamp. I heard them at RMAF 2006 and was extremely impressed. BTW, I am basically a tube guy.

I had the same issue with my Manley Stingray and a power cord from DCCA placed on my Cary cdp solved the problem.
Started with Don's Source pc which did a good job and now I'm using his Ref 1 on the Cary and honestly, the bass couldn't be better.
Just my 2 cents.
Good Luck!

Presumably the woofers on the Ushers are wired in parallel, so the impedance is lower at low frequencies than in the treble region. Maybe only one woofer goes up to meet the tweeter.

At any rate, a solid state voltage-source-approximating amplifier will deliver double the wattage into a 4 ohm load as into an 8 ohm load. The speakers were designed with this expectation in mind. On the other hand, a tube amp is less likely to approximate a voltage source, and therefore less likely to deliver the increased power output into low impedances that the speaker was designed to take advantage of. So in the region where the two woofers are operating in parallel, the net output with that amplifier is less than the speaker's designer intended. The result is weak bass.

That's my guess, anyway.

Duke
dealer/manufacturer

YOur tube pre (or CD player) may have inverted polarity/phase. Meaning you need to switch the +/- speaker leads at the speakers

Icorem: Just for the hell of it, I replaced (only for a short period) my PrimaLuna 6 monobocks (70wpc) with my old acurus a150 solid state amp (150 wpc) just to see what the difference would be. Besides the obvious immediate differences, I noticed the biggest change in the sound was the lack of bass the a150 had compared to the tube monoblocs.
food for thought. good luck.
jorge