Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
So going to order this LS. My Placette makes noise for some reason when plugged in.
I received my LSA last week. It's working WONDERFULLY with my Job 225 amp's 51K Zinput. The 51K concerned me so I put off buying the LSA for a couple months. My only regret is not doing it sooner.
By the way, this is the second time I purchased an LSA from George and the second time I wondered why I even considered anything else.
Hi Devilboy, glad your enjoying the Lightspeed with your setup.
There is no problem with the 51k Z of your amp. As we have done extensive A/B listenings tests on a very high rez system with amp input z loads from 300k right down to 33k, and only then did 2 of the 40 Audiophile listeners think they detected a very slight change when we got to 33k.
Just use good qualtiy interconnects from the Lightspeed to the amp/s at 2mt or less.

Cheers George
cable question: should the cable pair with the lower capacitance go between the LSA and Amp or the Source and LSA or does it not matter?

I just upgraded my cables but the more expensive cables have twice the capacitance as my cheaper Blue Jeans.

Both pairs are 2 feet.

Thanks...