Class D and High Efficiency Speakers?


G'day guys,

I'm just curious at this stage (not allowed to change yet) about using class d amps such as the Nuforce ref 9 with 98db efficient horn speakers. Obviously being such high efficiency they only need a couple of watts (I'm currently using 300b mono-blocs). Will they have adverse effects or over power the speakers?

What are peoples thoughts?
warnsey1
I tried, keep going with tubes. But since I manufacturer loudspeakers I have to keep class d about to test on loudspeakers. Why not a class a ss amp? I find these better than Class D.
Johnk,
Understood.

As a retailer I have various class d amps here which I switch in and out of systems to understand the strengths and weaknesses.

They are a godsend for difficult loads when space, heat, and budget constraints exist.

And the sonic quality is becoming very very good with the proper load.
09-19-08: Audiofeil
Let's not confuse snobbery with years of experience.

Of which I suggest you seem to lack.

Good luck with your Onkyo or Pioneer or Kenwood or whatever.
Thank you. I rest my case.
Johnnyb53, trust me, Audiofool, will not give it a rest. He knows all. Good luck.
The subject of class D always seems to bring on the detractor who's class D experience can be limited to varying degrees. My red flags pop up when I hear the general reference to class D and not a specific model.

While I still own a fine tube and linear solid state amplifiers I'm terribly class D biased. Class D amplifiers are far more sensitive to their physical and electrical environment than most other designs. In many cases AC line conditioning can simply make things worse. Class D is not plug and play.

Warnsy! Your own advise is the best so far, try it yourself. I did hear a system with some home made horn enclosures powered by an early version of Red Wine amplifiers and the music was stunning. I haven't followed Red Wine's progress but I'm sure they've been busy improving their design.

My personal switching amplifier advances have come from: a dedicated shielded AC Circuit, mass loading the casework, replacing a tubed preamplifier with a battery powered solid state preamp.

Of the eight class D amplifier I've had in my system and either before or after my systems upgrades I have never experienced what someone referred to as 'switching noise' from the amplifier. As I understand it the switching occurs at 50kHz and usually much higher.