2. amps-preamps
  3. 1232173975

binding post break in

yesterday I replaced my binding posts on my rogue audio m150 monos with the highly regarded wbt nextgen copper binding posts and yes there was more detail,but it was also thin and not as harmonic and rich, and not as open sounding as before. I have been listening to the wonderfull sounding kenny burrell guitar forms latey and have really liked how it sounded on my system,but after I put in the wbts his guitar sounded strummy and hooded , the higher strings sounded thinner and the middle and lower strings sounded sucked out . well crap. is this another case of [ it needs 256 and a half hours of break in and then it will sound great!] or what? has anybody out there had any experience with these binding posts ? I am very good at soldering so i dont think that a bad joint is the reason I am hearing what I do, any ideas ? is there a richer sounding binding post with some body and still very good low level detail ? or will they really change that much with some break in ? thanks , chris
chrissain
stilljd
161 posts
 
Chrissain,

It sounds like you took great care but, could one of the soldered connections to the binding posts be a cold solder joint? Your process description seems to leave a little room for the possibility.

Jim S.
shadorne's avatar
Ag insider logo xs@2x
shadorne
7,477 posts
 
Binding post break in?

ROTFLMAO

You guys can all laugh...but my local S&M club takes this very seriously. If you ever got badly chaffed wrists then it is no laughing matter!!!
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
You guys can all laugh...but my local S&M club takes this very seriously. If you ever got badly chaffed wrists then it is no laughing matter!!!

See the thread about contact treatments. Maybe the Walker stuff would be helpful!

-- Al :)
chrissain OP
470 posts
 
Im starting to think that bad solder joints have to be what I am hearing, the solder is inside the folded binding post so there is no way to really tell. maybe because the folded metal acted as a heatsink and the solder did not get hot enough. crap....
timrhu
2,779 posts
 
Unlikely it's a bad solder joint if you crimped the wire in the connector IMO. If you have a solid mechanical connection between the post and wire then the connection isn't the problem. I would argue that if a solid connection is made via a good crimp, soldering the connection isn't necessary for signal transfer. The solder is used more as a binding agent to maintain a solid connection.
The problem, as I understand your description, is just a change in tone. If that's the case your problem doesn't sound like a defective solder joint. Unfortunately I don't have any other suggestion.
More to discover