Buffer pre or active pre...

Regardless of the terminology the manufacturer's literature may use, both amplifiers are active. An active device in the context of amplifiers is a tube or transistor. It is the opposite of a passive device, which can refer to a resistor, capacitor, inductor, transformer, switch, etc.

The buffer amplifier has, presumeably, a gain of one, or very close to it. The amplifier with four 6922's presumably has a gain considerably greater than one.

The two-tube amplifier "needs a little more crank of volume" than the four-tube amplifier simply because it has less gain. It's hard to generalize beyond that.

Regards,
-- Al

Hi5,

It appears that you are talking about an active buffer linestage with unity or close to unity gain vs. an active linestage with some gain. If you don't need the gain, the simpler circuit should sound better. The buffer linestagestage, if well designed, would not be distorting at or near full output.

Because this is a tube unit, I would guess that the circuit is a cathode follower (to keep output impedance reasonably low). I have no personal bias myself, but, some people don't like that kind of circuit, so, the issue of whether a passive would be more desirable becomes more of an issue (assuming, again, that gain is not needed). Passives have their own issues, so, the choice becomes an issue of system compatibility and tradeoffs.

Thanks all..

These two pre are based on MFA ref MC one. My friend made this with high quality printed circuit board (great skills he got).

OK, about the gain I think I don't have any issue. I'm using VTL MB250 signature (250wpc) with Naim CD5/Fcap2. After extensive listening I still can't make up my mind on which to go.