Tube Question - Do they need time to "Break In"

I'm just answering your question.

There are other parts, capacitors for instance, that sound "better" with some time.

Don't forget the "human factor" as well. You become acclimated and more comfortable (in most cases) after a bit of listening. You may perceive the system as sounding "better" as a result.

Lastly, much of our enjoyment or dissatisfaction with our system is dependent on emotional state. I'd bet that after a good meal, your favorite team winning, or a relaxing day the system sounds great.

Conversely, after a fight with the wife, bad day at the office, or having the air conditioning crap out on a hot/humid day your system may not sound as "great" as the day before when everything was running smooth.

IMO of course.

My preamp takes about an hour before it sounds best too. I think the warmup period is not for the tubes, but for the other electrical components within the preamp.

My experience is that tubes do take time to break in. Two years ago, I bought a pair of new Full Music Meshed-plate 300Bs for my SET amp. When I first powered them on, they would not even hold biases. They also sounded muddy and closed. If you looked at the meshed plates long enough, you could see their brightness changed!

After 200-300 hours, they started to open up and hold the bias levels. Now they work perfectly. I really like these tubes!

Do you wait until they're warmed up before playing music? My McIntosh has about a 30-second "tube-warmup" before it'll play. It literally display "tube-warmup" on the front LEDs. My Cary 120S manual says warm-up time is 3 minutes. The tech at Cary Audio said it was ok to start playing pumping music through as soon as the amp is turned on but I take his technical advice with a grain or two of salt.

02-07-09: Cyclonicman
My preamp takes about an hour before it sounds best too. I think the warmup period is not for the tubes, but for the other electrical components within the preamp.

Bingo.

I have some all-tube guitar amps, and once the tubes are up to operating temperature, they're ready. Having been a solid state hi-fi guy for decades, I was really surprised that I could immediately hear the difference when I swapped in some '60s-era NOS RCA grey glass 6V6GTs for the stock Sovteks in my all-tube (including rectifier) Top Hat combo amp. No break-in or settling in required. I think it's the SS components that take awhile to reach optimum operating temp and attendant tolerances. I keep many of my SS components on all the time for this reason.