High Current SS amps with input impedance = 200K


I'm looking to identify amps like this that would match optimally to an Audio Research sp16 tube pre-amp with output impedance of ~ 20K?
128x128mapman
Post removed 
Post removed 
Mapman, Bob may be 'right' as Tvad sez, but the ratio is way beyond any nominal ratio you see bantered around like 10 to 1 for example. In this case it would be very close to 80 to 1.

Personally I'd tend to trust ARC when it sez a 20K imput impedence would be adequate (I actually did that without regret) and not get my panties in a knot over what the difference would be between say 20K and 47K or even 100K. I'd even take bets that in this instance even Bob couldn't tell the difference if he was listening with a stethoscope. In fact I'd take bets that it would be unlikely that he would hear any meaningful difference if the amp's input impedence was as low as 10K.

Personally I'd believe ARC. I'd even go so far as to think that their recommendation would be conservative and act accordingly, spending the copious amount of time necessary to solve these issues to insuring that the amps output impedence was a good match for the speakers to be used, to finding the right tubes to flesh out the pre-amp's tonal issues when matching it with any particular amp, or just sitting back and listening to some good music.

But hey, thats just me. I'm not very anal about all of these techie issues. :-)
Post removed 
Tvad, Note I said no difference at 20K or above, but I did add the words 'unlikely' and 'meaningful' to the reference to 10K. To me at least it probably wouldn't be 'meaningful'. I draw this assumption from my personal experience using ARC stuff and assorted SS and tubed amps with input impedances between 10K and 100K. I get far more wound up working out amp output and speaker impedence matching issues (as I know you do as well).

BTW, Tvad, have you actually heard the SP16 connected with a 10K amp AND an identical amp differing only in that the impedence value was increased to 20K. Im unaware of any such amps though. I think if we could find a techie who could set up such a demo by altering the output impedence of some amp in some way without otherewise changing the signal, we might then, and I think only then, know if there was a difference, meaningful or not.

But its fun thinking about all of the issues anyway. :-)