What direction should Hi Fi tune fuse be installed


What direction should Hi Fi Tuning fuses be installed? They have a little arrow and I would think it would point the direction of AC flow but maybe it points to the AC source?? SEEMS to sound better that way. I know someone will say put it the way it sound better but i have 3 fuses here. That is 6 possible ways. Not in the mood for that. The arrow must mean somethuing. What about Furutech? Thoughts welcome. keith
128x128geph0007
Mapman, please just go ahead and buy any fuse that works and stop trying to muck up the discussions that other wish to have with more empirical listeners.
"Mapman, please just go ahead and buy any fuse that works and stop trying to muck up the discussions that other wish to have with more empirical listeners."

Tbg, my ears tell me I am an empirical listener just as yours tell you which direction the fuse sounds better.

Sorry if my views and opinions conflict with yours. Im sure it is very inconvenient.
05-13-14: Joe_appierto
Is it possible the fuse is constructed in such a way that it performs better one way than the other.
That of course goes to the heart of the debate, Joe. From a technical standpoint I cannot envision any mechanism by which that could occur. As you may have seen in reading through the thread, though, my instinct has been to not question the perceptions of those who report hearing differences (although I certainly would not rule out the possibility of flawed perception in all cases). Given the lack of technical plausibility, it seems to me that the most probable explanation is that reported differences are generally due to unrecognized extraneous variables. The leading candidate perhaps being differences in contact integrity as the two orientations are tried. Perhaps also differences in equipment warmup state, and fluctuations in AC line voltage or noise conditions.

Which is why I have emphasized the desirability of performing comparisons while going back and forth between the two orientations several times, before drawing any conclusions.

Best regards,
-- Al
Al and Mapman, I don't mean to put your feet to the fire, but could either one of you kindly post a quote from an aftermarket fuse manufacturer, any manufacturer, where he states that "the fuse arrow is supposed to be in the direction of current flow." I'm pretty sure this whole "in the direction of current flow" is just something that naysayers, in lockstep, picked up on after it was repeated a thousand times on the Internet. Kinda like Morphic Resonance, the hundred monkeys thing. It's called a Strawman Argument. Hel-loo!
Geoff, I have not asserted that the fuse manufacturers assert that their fuses should be oriented in the direction of "current flow." As you say, that might simply be something that has been "repeated a thousand times on the internet," though not particularly by the naysayers. Just take a look at the early posts in this thread, or at the statement in the paper Joe referenced that "both the HiFi Tuning and Isoclean fuses have arrows on their cases which indicate that they should be oriented in the direction of current (energy) flow."

What I have maintained is that the various explanations and measurements that have been offered as rationale for fuse directionality are flawed, and that IMO the explanation of reported differences that has the greatest probability of being correct is failure to recognize and control extraneous variables.

Regards,
-- Al