I personally like the KT-88 type tube for having authoritative bass with beautiful mids and highs. This tube was invented for audio, and is readily available for reasonable prices. A parallel single ended integrated amplifier (using 2 KT88s per speaker) offers 30 watts. But, in reality, w/ spkrs that have 101db of sensitivity, "how many" watts should not be the concern but rather "how good" of a watt can you get. Your spkrs actually do the work in this case. 3 watts should knock sheetrock off your walls. I still like the sound of the KT88 type tubes though and even a single ended amp using (1) kt88 per spkr. will offer 15 watts. Also, don't overlook the importance of the output transformer (not in OTL amps of course). The best sounding amps will only come from the best, musically driven manufacturers. I also credit the CD player with providing the quality of sound that the rest of the system gets to work with. Once your music leaves the CD player, it will not get better. It will get worse, but not better. Actually, to get the best sound per dollar spent, make sure everything in your system has similar quality. (spkrs, cabling, electronics & especially the source) Just my opinion. Hope this helps.
Enough SET Power for Rock and Roll
I'm still trying to figure out what SET amp would sound best for Rock and Roll (and other music but especially Rock) on Klipsch Cornwall II speakers (101dB efficiency) in a room about 18x13 (with kind of medium acoustics - not live, not totally dead.) On a Marantz 2230 (which sounds very good, surprisingly good for being ~35 years old and 30 watts of solid state) I found that when I crank up the Rock and Roll on the Cornwalls I'm listening from about 89dB to 97db, but frankly if I wasn't worried about clipping or blowing out the speakers or receiver I could probably enjoy an occassional 100 dB :) - but if I have to live at 97 dB and below I could. (Measurements made with a Radio Shack meter set on fast, C weighting - taken from 1 meter away from the speakers, and also at the main seating position which is about 10-11 feet from the speaker plane.)
From many posts here and over on AudioAsylum it sounds like a 45 SET amp would sound great but might not have enough oomph - although that isn't 100% certain. It seems that a 2A3 SET amp would have a better chance of handling the loud music and the "complexities?" of Rock (and orchestra music) vs. say simple instrumentals and vocals. Next up would be a 300B SET, more power but some people seem to think it gives away some of the "magic" of the 2A3 and especially the 45. It isn't so clear to me from reading the various posts how any of these tube types do on the low end; I think low end (reasonably deep and tight) is needed to do Rock and Roll well - but so is good midrange and highs, so it's a balance, of course.
What do you think, more power and listen loud with ease, ie go with a 300B, or can a 2A3 or possibly a 45 do it all? Or is it possible that SET just can't do Rock and Roll seriously with 101db speakers in a 18x13 rom? In which case, next up is what kind of tube amp? If SET makes sense, I'd like to give it a try but I don't want to push physics or the budget too hard with experiments that aren't likely to work.
Thanks!
From many posts here and over on AudioAsylum it sounds like a 45 SET amp would sound great but might not have enough oomph - although that isn't 100% certain. It seems that a 2A3 SET amp would have a better chance of handling the loud music and the "complexities?" of Rock (and orchestra music) vs. say simple instrumentals and vocals. Next up would be a 300B SET, more power but some people seem to think it gives away some of the "magic" of the 2A3 and especially the 45. It isn't so clear to me from reading the various posts how any of these tube types do on the low end; I think low end (reasonably deep and tight) is needed to do Rock and Roll well - but so is good midrange and highs, so it's a balance, of course.
What do you think, more power and listen loud with ease, ie go with a 300B, or can a 2A3 or possibly a 45 do it all? Or is it possible that SET just can't do Rock and Roll seriously with 101db speakers in a 18x13 rom? In which case, next up is what kind of tube amp? If SET makes sense, I'd like to give it a try but I don't want to push physics or the budget too hard with experiments that aren't likely to work.
Thanks!
- ...
- 42 posts total
- 42 posts total