Van Alstine?

Tonyptony,

Very insightful. Thank you.

There are very few recent posts concerning AVA so any additional information would be appreciated. There is also the Odyssey Audio Stratos and I am leaning towards these companies because they are designed and manufactured in the USA. If the quality is the same and the design is sound it is my preference. I am using Bel Canto M300 monoblocks which are also designed and built domestically and am thinking of a change. Thanks for any advice you can offer.

If you haven't done so already you should check out AudioCircle.com. Both AVA and Odyssey users are well represented there.

A few years back, I was running a Pioneer AVR in my combo HT/2-channel system, and had a Rotel RMB-1066 amp, run bridged, for the front three channels. With my old speakers (Vandersteen 1C), this was a bright-sounding combination. I decided to upgrade to a new three channel amp, but limited myself to brands I could try at home. It came down to the Omegastar three channel amp and the Odyssey Audio HT3. The Van Alstine was somewheat less money, so I had high hopes, but was dissappointed. I found the V.A. sounded even brighter than the the Rotel. It was especially highlighted in the brightness range (~4-8kHz). I returned it to Van Alstine. Frank was gracious, but somewhat miffed that I did not like his amp (he really tries to make a high-value product that pleases customers). The Odyssey Audio HT3 (with cap upgrade) was completely different. It is super smooth throughout the audio band, including that crucial brightness range. Even so, it offers up plenty of fine detail and decay. Good dynamics, soundstage width (less so on depth, IME). I did have a cap go bad a few months in. Other than the hefty shipping fees, the repair was painless and it has been fine in the five years since. Note also that ground hum was an issue at first. Klaus of Odyssey had me remove an internal ground wire, which helped a lot. A later addition of a PS Audio Quintet made yet another improvement, and I no longer consider this an issue.

Hi, Bondmanp. I'm sure you did hear an increased brightness with the Van Alstine: I don't question your data. I do, however, question the conclusions that you draw from the data. Van Alstine amps are not "voiced" to have an emphasis in any particular frequency range, and they measure flat across the audible frequency range and beyond. (Some of the older reviews have test bench data in them, and AVA hasn't diverted from their design goals over the years).

Since the AVA is passing all frequencies cleanly through, without emphasis (as a test bench verifies) I would suggest that if an AVA amp in your system leads to a "bright" sound then you are getting an honest look at some part of your system that is out of whack. What room treatments are you using to control reflections that can accentuate the high frequencies?