2. amps-preamps
  3. 1293926134

BAT REX power consumption

I'm considering moving to a BAT REX, but have some concerns regarding the power consumption. The specs indicate 470 watts total between the power supply and main chassis. Even the 52SE puts out 250 watts. I don't think I've seen any preamp putting out more than 100 watts, with most consuming considerably less. Is this something, outside of increasing one's electric bills, to be concerned about?
lula
rtn1
535 posts
 
OK, that's more helpful. How much do you have running on a 15 amp line, and can you get another line to your stereo? It sounds like a single circuit may get overloaded.

My stereo runs on 2 dedicated lines of 10 gauge wire and 20 amp breakers.

Standby uses less, but I'm not sure exactly how much less. That's probably a Victor question.
lula OP
208 posts
 
My understanding is that a 15 amp line can accept between 1650 and 1800 watts, based upon 110-120 volts. I should be safe if the Rex actually consumes 300 watts even with all my sources on at once, although not every component lists power consumption. It's not a dedicated line, but only a few light bulbs rated at 13 to 20 watts are ever on, aside from the audio equipment.
coltrane1's avatar
coltrane1
682 posts
 
Cut to the chase. Call the designer builder. Victor will answer any question you have. No one here built the pre. Take your questions to the source. Simple right.
lula OP
208 posts
 
Auxetophone,
Did you get a reply from Victor regarding the power consumption?
auxetophone
114 posts
 
Yes, he says 470 watts is correct.
More to discover