2. amps-preamps
  3. 1300509890

Vintage Amps - Pleasantly surprised

A while back, i was given a non-functional Sansui AU-666, which I recently had restored for sh*ts and giggles. Hooked it up to Rega Aras in my bedroom, using a computer source with a basic NuForce uDac.

Honestly, i was not expecting much out of this combo. However, I am blown away by the sound quality i'm getting out of this extremely modest setup. It shockingly possesses much of the desirable 'audiophile traits' one would typically hope for. I'm not saying it's perfect, but for a 40 year old piece, i'm utterly stunned.

And considering the entire setup cost less than 450 bucks, including stands (excluding computer, but which i had already), i could not have asked for more.

Anyone else with this kind of experience using vintage gear?
loose
timrhu
2,779 posts
 
I recently purchased an older (mid 90s) Harman Kardon amp on ebay. After giving it a thorough cleaning and then rewiring it I am amazed at how good it sounds. I'm seriously considering using this as my main amp. Take a close look inside and you see very simple circuit design with all discrete quality components nicely laid out.
Install an IEC socket, rewire the A/C input and output section with quality binding posts and nothing to complain about. If you think about the process of amplifying an audio signal, not a lot has changed over the last 30+ years. Buconero117 has a point.
corazon
210 posts
 
Catama,

I have a few of the same pieces. Have seen the 17s on ebay alot. Have been thinking about Model 6's. Any thoughts?

Best,

Dave
stewie
187 posts
 
Same experience with my restored Kenwood Supremes, 600 and 700m. Beautiful aesthetically and sonically.
weseixas
519 posts
 
Agree on the sansui stuff and will add , Sony, give there seperates a listen, you will be suprised.

regards,
iraj
1 posts
 
Don't mean to hijack the thread, but I'm using a Nikko Beta 30 preamp while I wait for a new Emotiva I've ordered. My problem is powering the subwoofer. The Beta has two outputs, but the myriad of buttons and labels don't tell me how to get both outputs working at the same time. I'm unable to get any signal to the Krell channel for the subwoofer. Does anyone have a manual for this model, or any suggestions to getting a signal to the subwoofer.

Thanks. IJ
More to discover