Tubes vs Solid State


I have have been listening to music all my life but have only recently started experimenting with different amplifier and/or speakers/component combinations. I have recently moved from Parasound JC 1's to Classe Cam 400 monoblocks which I have both loved (maybe the prior a bit more) and are contemplating another move. I have been very intrigued by tube monoblocks and have the opportunity now to move to ARC ref 600's. I can also get Mark Levinson 33's for about the same cost. I am just uncertain about the Ref 600's as I am worried that I might be disappointed in the tube sound.

Can someone with more experience perhaps help me out here ? I am using the amps as part of a home-theatre setup driving 802 d's and other 800 diamond fronts and rears. I would really appreciate some good advice here.
gfdt
Matching amps and speakers is important!

Take a look at this link:
http://www.atma-sphere.com/Resources/Paradigms_in_Amplifier_Design.php

The B&W 802 is designed to work on an amplifier that can double its power when the load is cut in half. Specifically, it has an 8 ohm midrange and tweeter, but the woofers are in parallel and so are 4 ohms. Not only that, but the woofers are 3 db less efficient than the mid and tweeter. To correct this, its expected that the amplifier will double its power into the lower impedance.

No tube amp can do this and so on this speaker, tube amps will have less punch in the bass. Now if you had a speaker that did not expect that of the amplifier, then you could get more punch out of a tube amp than a transistor amp...

Its all in the match. Of course its my opinion that tubes offer more music much easier than transistors do (I know of one transistor amp that is really musical but it retails for over $100,000...).

Another issue with 4 ohms is that the speaker cable is more critical and also that any amplifier driving 4 ohms (tube or transistor) will not sound as good as it does driving higher impedances. So if you are seeking musicality, you may want to consider replacing the speaker as well.
If you need to stick to the B&W's, stick with SS. In addition to all the reasons stated, tubes will be unstable with the loads the B&W need. I had a similar problem with my B&W's but I then sold them off to get speakers that were tube friendly.
I use the Rogue M180's with KT 120 tubes to drive Martin Logan Summits (which present a very difficult load to amp) with very good effect. You can retube yourself as there is a built in bias meter.
I would pay close attention to ralph's (atmasphere) response as it is probally going to be one of the best ones you will receive.
I`m a person who generally prefers tube power amplifiers but it all depends on the speaker being driven. I agree with Atmasphere,Unsound and others in this situation.Your speaker design seems to demand SS amps given it`s difficult load characteristics.