Replacing 6550s with KT 88s

Rodman
Many thanks. You are absolutely correct.I intend to do this slowly and in phases to try and guage the effect of each tube. Am interested in your comments/experience of the NOS 6550s vis a vis the Winged C current production
Cheers
Pradeep

I had been purchasing NOS Sylvania 6550's, from Upscale, until his supply ran out. Went to the =C= and felt I was missing nothing(at that point). Those had over four years on them when replaced with the NOS GE 6550A octet. Thus- I can't offer a valid, direct comparison. It's my impression, however, that the GE's are a more dynamic, open & cleaner tube, than either the Sylvania or =C=(at the same bias setting). Once you have listened to your rig with the new compliment of tubes for a time: Try some NOS Siemens E188CC's or 7308's(direct replacement, identical in every parameter to the 6DJ8/6922), in your phase splitter and driver slots.

Rodman
Thanks that seems a sensible way to go as the price differential between NOS and current production for phase splitter and driver tubes, at least in Singapore , is much lower than the 6550 power tubes.
Will post my impressions post makeover.
Cheers
Pradeep

WOW- Singapore! I'll bet tubes ARE expensive over there. I've purchased quite a few Siemens tubes(in the past 12 years), from this vendor in West Germany. He's very reliable and sells excellent tubes: (http://myworld.ebay.com/audiotubes_de&ssPageName=STRK:MEFSX:SELLERID&_trksid=p3984.m1543.l2533) I started dealing with him long before he sold on eBay. Yes- Rolling preamp, driver and splitters is less expensive, UNLESS your tastes lean toward the pre-1966 Siemens CCa(I use six in my system), Tung-Sol CTL/6SN7GT round plates(two) and Sylvania CHS/6SN7W tall bottles(two). The sound staging, extension, air and liquidity of these tubes is addictive(and, YEAH- I'm hooked). I'm getting sick, just thinking of what will happen, when my personal stash runs out(OUCH). Looking forward to your impressions, post-swap. Happy listening!

Sunnyboy, my amp is an ARC VS-115 which originally came stock with 6550C tubes. Since then ARC switched out to the KT-120s, which is what I used now. Bought the KT-120s from Upscale Audio. In my opinion, the KT-120s better the 6550C tubes in pretty much every way. If your amp can handle the extra current demands, consider the KT-120s. But check with the factory first!