Simple Biamp question

I have no idea why the fact that the amps are stereo would be an issue. The fact that they said that lessens their credibility, IMO.

One conceivable issue, though, is that there are some speakers that provide two sets of binding posts for biwiring purposes, but do not have low frequency and mid/hi frequency crossover networks that are independent of each other. In those cases, although the speakers can be biwired they may not be suitable for biamping. Don't know if that applies to the Allison Fours.

Regarding impedance, it appears that the speakers have a nominal impedance of 8 ohms, and the amplifier provides 8 ohm (as well as 4 ohm) output taps. So I would expect impedance to also be a non-issue. The one conceivable concern that occurs to me, though, is that the mid/hi amplifier channel would be running essentially unloaded (i.e., into a high impedance) at deep bass frequencies, and likewise for the low frequency amplifier channel at high frequencies. It is not healthy to run a tube amplifier having an output transformer unloaded, because it creates a risk of amplifier damage from something called "inductive kickback." But I see no reason to suspect that that risk in your situation would be any greater than in any other situation where a tube amplifier is used as part of a passive biamp setup, which is commonly done.

Regards,
-- Al

Al, thank you for your valued input. Why would the absence of independent crossovers make them unsuitable for biamping?

Why would the absence of independent crossovers make them unsuitable for biamping?

It is conceivable that if the speaker is not designed to be biamped its design could be such that it would short the two amplifier channels together, either directly or through some low impedance circuit path. That could be unhealthy for both the amp and the speaker.

In that situation the risk of damage would be reduced somewhat by the fact that both amplifier channels will be putting out signals that, to a close approximation, are identical. But if you don't have a manual for the speakers, or if the manual does not address biamping, it would be prudent to do some Googling to see if others have biamped that speaker successfully.

Regards,
-- Al

Vertical biamping works wonderfully with my Monarchy SM70 Pro amps. Sounds much better this way than using them as mono-blocks, for some reason. I am very happy with the setup.

Al, I think that's at my repair guru implied - I misquoted him about stereo vs mono- so I am afraid of blowing up both amp and speaker by shorting the 2 channels. I have just asked in a new thread whether anybody has biamped Allison 4s. Thanks again for your input.