Lyra Titan i - in focus?

Thanks Peterayer. Did the Mint protractor measurement make you move the arm forwards or backwards in the base compared to the SME protractor?

Very slightly forward on the V and very slightly back in the V-12. But perhaps more importantly, it showed at the null points that the cantilever was not quite tangent to the groove, so I had to twist the cartridge in the headshell and it made a real difference.

Peterayer - this is very interesting. In my case I have always felt that the Titan (and earlier Lyras) had to be shifted slightly to the right, seen from the front of the record player. With the SME V arm, you cannot change much, but I took the freedom to bore the circular screw holes slightly oblong. Thereby I can turn the pickup a slight bit towards the right in the shell (seen from the front), to make it sound its best. Is this in line with your experience?

I was able to get all the movement I needed within the existing mounting holes. My rough guess is that I rotated the cartridge about it's zenith axis perhaps one (1) degree or 0.2 mm at it's rear edge. It's hard to say, but I rotated it as far as possible within the allowance and the cantilever lined up perfectly with the parallel guide lines at the two null points on the MINT LP protractor.

I also noticed that the stylus was off the arc by about 0.5 mm at the lead in groove, but appeared on the arc near the spindle. I could not see this but I could with the 10X loupe that is provided. So it took a bit of back and forth in very tiny increments to get it all lined up.

The overall sound became more clear and detailed and there is less tracking error at the inner grooves. The standard SME template is close, but the Mint is more precise. The problem is that one has to know EXACTLY the effective length of the arm (pivot to stylus) and that is nominal in the SME case because the mounting hole to stylus distance varies by cartridge sample and then you have to account for the headshell angle to do the math.

It was complicated, but I sent the figures to MINT and got the protractor.

Now, remember that I'm not suggesting that this is the solution to your particular issue. It is only a suggestion. VTA/SRA is also important as is VTF. Some would argue azimuth is also, but the SME V/V-12 don't have azimuth adjustability.

I also set the antiskate to the SME recommended setting corresponding to the VTF. The dial is calibrated. Others suggest that is too high a setting. I listened a lot to different settings and found the recommended setting sounded best in my system.

You also need to have clean records and a clean stylus.

Thank you for interesting information. I've found that I have to twist the pickup to the right (seen from front) in the SME shell to sound its best, and to appear best judging from optical adjustment with different protractors too. Is this in line with your experience? Regarding antiskate, I generally prefer it a bit more relaxed, a degree or two below the weight measure. This is related to arm damping also, I have tried a bit, but ended up not using it.