Pass labs XA60.5 anything wrong with them.

07-11-13: Tonywinsc
60 Watts is a lot of power even for speakers not so efficient. Lets say you have a speaker that outputs 89dB at 1Watt/1meter. That results in an SPL of 97dB at 3 meters with 64Watts. That is pretty loud unless your goal is permanent hearing loss. 100dB is standing next to a pneumatic jackhammer, for example. I guess the question is does a class A amp still sound as good at maximum output as it does at 1 Watt.

This analysis does not take into account the dynamic range of the music, however, meaning the DIFFERENCE in volume between the loudest notes and the softest notes. Well engineered minimally compressed classical symphonic music, for example, can easily have a dynamic range of 30 db or more, and a few such recordings in my collection even exceed 50 db.

A dynamic range of 30 db means that 1000 times as much power will be required for the loudest notes as for the softest notes. 50 db means that 100000 times as much power will be required for the loudest notes as for the softest notes.

On many such recordings, I find that brief peaks reach 100 to 105 db at my listening position, although average levels may be in the 70's or even less. Due to their brevity, and the moderate average level, those peaks do not represent a threat to one's hearing.

On the other hand, many and probably most rock and popular recordings these days are compressed to a dynamic range that is in the single digits, meaning that less than 10 times as much power is required for the loudest notes as for the softest notes. Your conclusion would certainly be applicable in those cases, IMO.

One minor additional point: In your example, since two speakers are being driven the 97 db figure is likely to be around 100 db, and possibly as much as 103 db.

Regards,
-- Al

Thanks for that info. I agree 100 percent. :D

For sure, total dynamic range must be considered. If you have your stereo volume set for the quietest passages to be at 40dB or so, just above the average room background level, then you have 57dB of headroom (considering 97dB max). Of course, I typically have my volume set at a point where record background noise is just audible on my quietest records at the lead in groove. I think that gives me somewhere around 40-50dB of headroom which can get pretty loud, and then my wife makes me turn it down. In general, speakers have a linear output of SPL (in dB) vs. power up to around 100-105dB- some less, some more. That is a generalized statment- better to consult your owners manual for more accurate specs. What that means is you can pump more power into the speakers but they will not get much louder. Some of that extra power will just turn into smoke:)

Thanks for your response.

I rarely see Pass Labs amps for sale, and I would so like to experience them, given all the raves.

But seeing 3-4 being offered for sale made me think that maybe these are underpowered (or too entry level at $11000!) and people move on to higher powered amps. Though I think for me 60W is more than plenty.

I am finally on the path of moving off from my Jolida 801A, if I pull the trigger this might be a super big jump.

I had them for some time. I also owned the XA-100.5 and 30.5. To be honnest for the money the 30.5 and 100.5 were better. These amps I used with the XP-20 Now I use the X250.5, overwhole sound I prefer a lot more over the XA60.5. The slamm and speed in the low freq are better. it is still a very warm and musical amp. It is a little bit more open than the XA60.5 The XA100.5 were a lot better than the XA60.5. The difference between the XA30.5 and XA60.5 is smaller.