What paint to use on power outlets

Kev:
I suppose that you have the plastic Ivory standard ones, right? Simply remove the covering plate and apply the same latex based paint used on the wall. will make them almost invisible if done properly. If you are careful enough you can do the same to all the outer parts, plug the holes, disconnect the breaker and do not dilute that much the paint. you might need to adjust technique and brush type to get a nice finish. flat paints tend to be more forgiving than eggshell or semigloss. Take your time be patient and you'll win some good points with her.
Regards
Luis

Use only cryo-treated Machina Dynamica Audio Paint with tiny ground up magic pebbles that invisibly work to stabilize, soften and take years off your aged home wiring. Accept no substitutes or you will regret it to your grave.

Marco

Clearly, someone has been sniffing the paint.

Jax2 is right on this. I tried some cryo-treated Machina Dynamica Audio Paint and the difference is not small. Tighter bass and more extended highs. The paint does require burn-in time however.

I found my system sounded best with an open can placed on my lap some 12 inches from my nose. After 60 minutes my system and music took on nice a 3D effect - wow!

Bill

Marco - LMAO!