Burn in question and evaluation before burn in

I am wondering if there is a general rule as to which direction any burn in would be heading

Seems to me to be pretty logical that the answer would be no. Obviously it would be dependent on the type of component (amp, cd player, preamp, speaker, interconnect cable, speaker cable, etc. etc.); and on the technology used (tube, solid state, dynamic speaker, electrostatic speaker, cone driver, dome driver, ribbon driver, electrostatic membrane, etc. etc.); the specific design of the particular example of the component type and technology, etc., etc.

I agree with Shadorne's comments as well.

Regards,
-- Al

I tend to avoid the type of gear that changes audibly. Manufacturers can design gear to be dramatically less affected by burn-in by simply designing it in such a way that it less sensitive to the things that do drift with use (capacitors, driver compliance for example).

Why don't you contact me via Audiogon. I see your comments here frequently and you seem to think caps and break in are a bad thing.

I can give you the name of the designer/ manufacturer that builds ALL the current hot caps that are on the market, sold under a dozen different names.

He will tell you break in is not only real but important. YES, it effects the sound greatly and if you think you can design around this, you are missing most of the great equipment on the market today.

Right on the money Albert! And any good designer will voice his equipment with the presentation of the components AFTER stabilization in mind. Hopefully- transparency will be their goal.

Albert,

I never said break in was not real. I just prefer components that are engineered to be precise and that do not drift dramatically with time. It is a simple design choice to place a capacitor in the signal path or not. It is a simple design choice to either place a capacitor in a passive crossover (where it adds distortion) or use a line level x-over filter. One can also design circuits so that they drift less with age and temperature through careful selection of components and design. I could go on about driver design as well -many drivers change dramatically with use due to thermal compression - every track the speaker may perform differently in some typical poor designs.

My point was to simply challenge the idea that burn-in that sounds greatly different is a good thing . It often implies overly simplistic designs that are commensurate with a goal of "purest signal path". Unfortunately, the engineering reality is quite the opposite - through added design complexity one can dramatically increase precision and robustness of product performance from changes in temperature, ground loops, cables, interconnects, power, noise, component aging etc.

Thanks for the responses. Shadorne, your point is well taken, actually, what prompted me to ask the question was that I was frustrated that my new solid state preamp sounded good at first install, but became too bright, and strangely, the tight bass was gone too after a week. I know I had only like about 30 hours playing time on it, so it is not fully burned in yet, but I wish I can be assured that further play time would kind of reverse the initial burn in direction, if that is at all possible.