best resistors

What Dgarretson describes is exactly what I had to do to make these work in the Counterpoint circuit board. There was typically 1/8" lead extended on each side of the resistor body and then each was bent back down to go through the circuit board holes.

Caddock resistors

Bending the leads of a resistor will not damage it as long as you apply common sense force. Another space saving orientation is to use vertical rather than horizontal space. This is done by leaving one lead straight and pushing it through the circuit board with the body of the resistor perpendicular to the board. now bend the lead on top of the resistor through the other hole. Once you get the hang of it, pre-bending before insertion is the way to go. Resistors don't care about physical orientation and as long as you have the vertical space this is the real estate efficient orientation.

Thanks guys, my issue is space limitations within point to point wiring within signal circuit. If you look at the pictures of the Cayin phono stage in my virtual system you will see I have severe space limitations, I'm not sure I can make any radial lead resistor work even with bending the leads. Now I could possiby rework the chassis and make more room.

It seems any axial lead capacitor will be a sonic compromise relative to the Vishay nudes. Very unfortunate if I want to attain maximum benefit.

Thanks Danmyers, I use this exact technique when fitting capacitors.

OK Scott, I looked at your system and you don't need modding advice from me :) Nice kit and some great mods, too. Good luck making it all fit cause I'm sure it sounds awesome!