Basically -if it's under warranty -I would return it for service and include the tubes you were trying to use.If the fault was caused by the tube - the importer will quit possibly charge you for the repairs.Now that's good advice. I forgot we were discussing a new piece. Something I rarely own.
Blown fuse and its soldering to a PCB
I need competent advice:
I purchased a new amplifier (Dared MP-60, made in China). It is cheap and rather good sounding, but its left side got dead (left-side tubes stopped glowing) when I replaced the stock 5881 tubes with RFT EL-34 (everything was OK for 30 min. but next morning, when I was switching it on, the problem appeared), though it was permitted by the user manual and was authorized by the seller.
When I opened the cover, I saw four 125V 8A fuses covered with opaque plastic cases. The fuses have leads soldered to the PCB. We measured them and indeed one was blown.
What is strange that the seller says "you can use unsoldered fuse, but there is no place to place a unsoldered fuse on the PCB". I asked for explanations ("Does it mean that the whole PCB must be changed or that the unsoldered fuse should be replaced by another fuse which should be soldered to the PCB?, and she said "Yes, there is no place to place the unsoldered fuse on the PCB, it means the whole PCB must be changed".
Is this PCB a single-use dummy (if it is possible in principle)? How can it be that the blown fuse must be unsoldered but the new fuse cannot be soldered to the same place in the PCB?
I purchased a new amplifier (Dared MP-60, made in China). It is cheap and rather good sounding, but its left side got dead (left-side tubes stopped glowing) when I replaced the stock 5881 tubes with RFT EL-34 (everything was OK for 30 min. but next morning, when I was switching it on, the problem appeared), though it was permitted by the user manual and was authorized by the seller.
When I opened the cover, I saw four 125V 8A fuses covered with opaque plastic cases. The fuses have leads soldered to the PCB. We measured them and indeed one was blown.
What is strange that the seller says "you can use unsoldered fuse, but there is no place to place a unsoldered fuse on the PCB". I asked for explanations ("Does it mean that the whole PCB must be changed or that the unsoldered fuse should be replaced by another fuse which should be soldered to the PCB?, and she said "Yes, there is no place to place the unsoldered fuse on the PCB, it means the whole PCB must be changed".
Is this PCB a single-use dummy (if it is possible in principle)? How can it be that the blown fuse must be unsoldered but the new fuse cannot be soldered to the same place in the PCB?
- ...
- 12 posts total
- 12 posts total