Hi Bryon,
The 14 gauge wire is certainly an "effective path" at low frequencies, and probably at frequencies ranging up into the ultrasonic and perhaps low RF region. But the inductance of a plain piece of wire will cause it to have a significant impedance at the high RF frequencies that constitute the spectral components of the ethernet signals. It will therefore not conduct those frequencies effectively. The impedance that is presented by inductance, as measured in ohms, is directly proportional to frequency. The inductance, btw, is directly proportional to length.
As I mentioned, for good conduction of RF frequencies to ground a braided ground strap, such as this, is needed. However I suspect that if you were to use a braided ground strap on both the network switch and the G68 you would wind up with worse results, because it would create a path that would conduct RF noise from the switch to the ground point, and from there to the G68, bypassing the reclocker.
It's easy enough to verify that on your particular computer. Disconnect the ethernet cable from the computer, and look for two small metal tabs on either side of the jack. Check for continuity from one of those tabs to the computer case and/or to the AC safety ground pin on the computer's power connector.
Best,
-- Al
The 14 gauge wire is certainly an "effective path" at low frequencies, and probably at frequencies ranging up into the ultrasonic and perhaps low RF region. But the inductance of a plain piece of wire will cause it to have a significant impedance at the high RF frequencies that constitute the spectral components of the ethernet signals. It will therefore not conduct those frequencies effectively. The impedance that is presented by inductance, as measured in ohms, is directly proportional to frequency. The inductance, btw, is directly proportional to length.
As I mentioned, for good conduction of RF frequencies to ground a braided ground strap, such as this, is needed. However I suspect that if you were to use a braided ground strap on both the network switch and the G68 you would wind up with worse results, because it would create a path that would conduct RF noise from the switch to the ground point, and from there to the G68, bypassing the reclocker.
Also, you mentioned that the shield of the 50' ethernet cable is grounded at the computer end. I couldn't find any information about that online. How can you tell?I should perhaps have qualified my comment by saying that that is the case with the desktop computers that I am familiar with, which primarily means those I have built myself using Asus and Gigabyte motherboards. On those motherboards, at least, shielded jacks are provided for the ethernet ports, the shields in turn being connected to the circuit ground on the board, which in turn is connected to the metal case of the computer and to AC safety ground.
It's easy enough to verify that on your particular computer. Disconnect the ethernet cable from the computer, and look for two small metal tabs on either side of the jack. Check for continuity from one of those tabs to the computer case and/or to the AC safety ground pin on the computer's power connector.
Best,
-- Al