Any woodworkers wanna offer some advice?

Most people use maple because it tends to absorbe vibration a bit more than some woods, has a tight grain and is a harder wood what you want for a rack. Stay away from pine it is ok but a bit soft I think unless you want to use alot of wood, if you want to go that rout popler is like pine a bit harder and a green tint sometimes, the nice thing is it is cheap. Oak is cheap and hard also but has a ruffer finish and you see the grain.

Instead of inserting nuts into the bottom you may want to find the proper threaded inserts that the speaker companys use. Some are better than others and some just wallow right out under the weight. I know that Salamander has a steel coupling that threads the spikes and support rods for their Archetype series. If you drilled a 2 1/2" deep hole you could insert these for a very stable rack.

Good luck with the project!

Hi,

Zeineth2 suggested that I throw my $0.02 to this conversation. Feel free to contact me at rhwoodworker {atsign} cox {period} net if you want more info.

White oak would probably be fine. Unlike red oak, it actually looks good, particularly if you show off the quarter grain by rotating those 2" legs 90-degrees. I.e., flat grain side goes left and right, 1/4 grain goes front-to-back... that way you'll more likely see the fleck pattern of white oak. I could look up the specific density of white oak if you'd like, but the density and hardness just might approach hard maple.

If you'd like to keep with the arts & crafts look, consider through tenons, wedged tenons, or interlocking joinery instead of straight (and rather banal) M&T.

For the shelves, you could save a dung-pile of money (used to buy more albums or CDs) by getting MDF and doubling it up with West System epoxy. The shelves come out to 1-1/4" to 1-1/2" thick, weighing... I dunno, 25 pounds each? I did this on two audio racks that I *just* built for my home, and they're superb, rock solid. If I'm not mistaken, MDF deals with vibration quite a bit better than granite. I'm looking into building a layer of Sorbothane into shelves, but haven't done the research, yet.

Now, for the fun part: I'm a woodworker, but my wife is a decorative paint artist. If you want, we could discuss building doubled MDF shelves and having her paint them to look like granite, marble, or any of hundreds of other finishes. She's really quite remarkable in what she can do - the best around. On our racks, we just went with basic black, but she uses proprietary products that are the best in the business. She could give you the look of granite or marble, and the weight of MDF for a fraction of the price you'd pay for real rock.

That's a start. Shout out if you want to talk about this.

Best regards,
Rob

You might check out some of the systems here on Audiogon. There are plenty of DIY racks. The only one that comes to mind now is Dan_ed. Good luck.

Thanks Rob, very helpful answer. Would have answered before, but managed to sneak out to Jackson Hole for few days over the New Years...

I was going to go with through tenons on the outside legs and for the front-to-back stretchers on the inside legs. For a while I actually thought about trying to build some quadralinear posts with rayflake on all four sides, but decided that wasn't worth it...

Think I may end up using your MDF shelf concept. Since I was going with absolute black granite anyway, I think I can probably paint'em myself and get a decent finish. Seems like it makes sense to do the glue up before cutting the shelves to final size for the best finish.

Anyway, maybe I'll figure out how to post some pics when I'm all done! Thanks for the help.