Will a Power Conditioner Help?

Ctacbka

If you are in the building stage, by all means add another ckt at least. Two if possible. Run the TV off the existing line.

Get the PC off the same ckt supplying the pre/pro and/or amp for sure. If it were me I'd place the PC and any digital source on a PLC. In fact, I have done just that.

Wether or not dedicated ckts are in play, PLC do substaintially add to the event. Which one? that's a whole other thread (s) and much is said here in that regard. Active, passive, regenerating and so forth.

But your short answer from me is yep. Add another ckt. first. Good power line filters like a PS Audio Duet (I have 2 of them), or their previous itteration, the UPC 200, or Hydra 2, 4, etc start at about $200 - $250> and actually do help.

If you run a 20A ckt. then on paper ONE conditioner can do the whole deal. Personally I prefer from experience, to employ added ckts and varied plc's, instead of the one size fits all approach. Strickly from a "unrestrained power" point of view.

In what way? Obviously it won't give you more power, in some cases it will give you less. The above response works assuming you had outlets to plug the conditioners into. Alternatively a more expensive PC can do the isolating in one box, but as noted won't up your power. What size outlet did you put in anyway (15? 20? 30? amp)? I'd move the computer somewhere else.

It may but the only way you can tell is to try one. What you are connecting sounds pretty modest - I would not worry about the load but an APC H15 may do the trick and tell you want current it is drawing.

Serus,

As a former LC-1800 owner, I have to vote against it. The voltage regulation is accomplished by switching transformer taps in 12 volt steps. What this meant was that, for example, if my line voltage of 120 volts went up to 122 volts, the LC-1800 put out 110 volts. I vote no on this one, especially if (like me) you own tube amps without regulated power supplies.
Not only is it a poor design in that regard, but it also doesn't sound very good in my opinion.

the big furman units ref 15 or 20IT are great for all --least expensive for front end stuff is powervar