2. cables
  3. 1051270505

High end PCs,,,,,in the wall or power conditioner?

Should high end power cords be plugged into the wall or a power conditioner? I've read that plugging them into a power conditioner can sometimes compress the sound.

I ask this because I would like to buy 2 Virtual Dynamics Nites but I can't afford to buy two 8ft cords to reach my wall outlets. I CAN afford to get two 3ft cords to reach a power conditioner but I don't want to take away from the sound quality.

By the way, I'd be using them for two Parasound power amps that I'm running in Mono (630 wpc).

Please help.
meech33
jsawhitlock
302 posts
 
You should run two dedicated lines, one for each amp and use 10 guage conductors doubled up for each hot, neutral and a single conductor is fine for the ground, along with 30 amp breakers, one on each amp. If you want to go a step further, pick up two PS Audio Ultimate Outlets high current model and plug each amp into them. I use two U/O high current with Classe Audio 25 amps running mono at 1600 watts per channel and they
sound better than plugging direct to wall with dedicated line. Happy Listening!
steuspeed's avatar
steuspeed
501 posts
 
Plug them in the wall! You could buy one cord and run one amp in stereo. Probably would sound better.

630 Watts is overkill for just about any speaker.
marakanetz's avatar
marakanetz
5,473 posts
 
Steuspeed,
Try Electro-Voice models that may require even more than 630Wpc(and can sound well if pumped hard!).
More to discover