2. cables
  3. 1014387737

RCA plugs that don't fit.

I've had problems with numerous interconnects lately that have WBT or WBT style locking RCA's. The connectors have been so tight that they won't fit on the jacks on back of my eqipment. This has happened on various types of equipment, and my only solution has been to unscrew the barrel of the connector and attach the cable without it. Has anyone else had similar problems and is there a solution I'm missing. The most important thing is not breaking the connectors on the back of my equipment while maintaining a secure connection.
128x128jond
10 responses Add your response
dekay's avatar
dekay
5,675 posts
 
Good point and I agree with HDM (the Bee Man:-) on this point. I did not find this out until I "forgot" to tighten a pair of HT Truthlink IC's in the midst of some cable swaps (they sounded much better somewhat loose). Natural instinct is to tighten the crap out of anything that tightens (except the oil plug on auto's), but this is not always the best way to go with these RCA's.
hdm
1,062 posts
 
Just as an aside, do not overtighen. Your best sonics will be obtainied by going about an 1/8th of a turn once you start to feel resistance with the locking RCA's. If you really crank them down hard, the sound will start to harden up as well and become quite bright. Don't overtighten!
ultrakaz
187 posts
 
The connector without the outside barrel sounds better, if it is not too loose and rf is not a problem. However, as the above posts suggest when twisting the barrel make sure that it is moving toward the rca connector on the component.
jond's avatar
jond OP
5,911 posts
 
Thanks everyone! I figured it out. Boy, do I feel like an idiot. Oh well, it's not the first time.
sugarbrie
3,854 posts
 
WBT connectors screw tighten. They are designed that way. You need to unscrew/loosen them. Hold the Gold part near the cable end and twist the black housing. If the end of the RCA plug is pointing up I think twisting left to right is loosen. Then insert into your gear and re-tighten.
glen's avatar
glen
714 posts
 
Some connectors are reverse thread. Are you sure your loosening the barrel correctly? Maybe take them to a hi-fi shop and have them checked.
dekay's avatar
dekay
5,675 posts
 
Perhaps shrink wrap or the cable's insulation is blocking the full movement of the outer part of the RCA. I had this happen once on a Mapleshade IC (the plastic insulation was in the way).
sean
6,231 posts
 
While i've never had such a severe problem as you mention, i have had some RCA's that are very, very tight fits. As Paulwp mentions, i've never seen a locking or "clamping" connector that could not be loosened up enough to slide it on. Most of my problems have been with non-locking RCA's that were either "under sized" on purpose (trying to make the most contact area possible) or simply not machined right to begin with. Sean
>
paulwp
585 posts
 
I've never seen one that you couldnt loosen by unscrewing to get on and then tighten (don't overtighten) on the jack. Unlike those Radio Shack cables that you use at your peril.
marakanetz's avatar
marakanetz
5,473 posts
 
I had the same problem with Cardas RCA. These RCA plugs weren't solid ahd had a "6-teeth" structure. I inserted a wire pliers inside and streched(very carefully) the opposite "teeth" on each plug.
Log in to respond
More to discover
80x80
Audio Art Cable Classic Plus Speaker Cable
80x80
AudioQuest Dragon 15 amp source 2M
80x80
Synergistic Research Galileo SX Interconnect Cables