@ghdprentice hit the wrong thing and have to start again. The front end has the sonic frontier transport and DAC three with reflector 6922s wired with furutech 55 powercord s and there top of the line plugs and IEC ends. A furutech evolution balanced interconnects. A Linn lp12 with a xlo reference ten powercord wire into it and a Linn kylde cartridge Linn interconnect a itok Valhalla table. The clear audio base table that is going to be the 78 playback system with a rega78 cartridge. That is balanced and will hook up to the Ayre k1xe phono stage and the Linn will hook up to the audio research reference one phono stage AP's with a set of reflector 6922 tubes. An Mr 71 McIntosh Turner With a st2 antenna. The Ayre k1xe has a transparent super power cord second generation with the three boxes the top of the line in that series cut the plugs off and installed furutech gold 48 plugs and IEC ends on it there are three dedicated 20amp circuit s that the front end plugs into. There are two with the top of the line furutech receptacle rodium plated and the other one is the top gold plated receptical. The Ayre is hooked via second generation transparent reference xl balanced interconnects to a pair of mark Levinson 33h mono blocks that have been recapped. Those amps have the top of the line furutech plugs wires on to them three more dedicated 20 amp circuit s on that wall one for each amp and one other the dedicated circuits are all on the same leg of the box they are all the same length the room is 16x23x7.5. the monoblocks are hooked up to the harbeth slh5 speakers via transparent generation three speaker wire. The speaker wire and s raised off the floor on powerline insulators. The speakers are on foundation stands. And all equipment is on thick blocks of dense hardwood purple heart and rosewood. They have brass points under them each has its own board. All are two inches thick or more.
System two is am Canary audio system. A pair of ca160 mono blocks with a ca 801 two box preamplifier and the Krell 20i cd player. Wired with a set of first generation transparent reference speaker wire. Furutech RCA interconnects and furutech 55 powercord and two more transparent super three box interconnect s with the furutech gold plated plugs. The Krell has a xlo reference power cord with the best furutech plugs and there furutech receptacles one gold two rodium the ones. The speakers are a set of equation 25 s.
The bedroom system has the Wadia 6 cd player with a melody h88 integrated amplifier that has been modified with oilers and it is an early made in Australia one with RCA tubes and a pair poison two dome phase speakers. Speaker wires are transparent ultra xl second generation. That also has transparent super interconnects and two box transparent plus powercords. Stock ends thinking I should sell them and buy some furutech powercords. Also a McIntosh mr73 tuner.
Home theater system four speakers is all neat stand mounts as rear surround and small front towers MIT terminator 2 speaker wires furutech HDMI cables and a Sony es blue ray player and a nad receiver. Same two box transparent power cords including the TV. A cheap 75 inch sharp tv lol the furutech HDMI cables were more money than the TV.
Bathroom system lol a set of kef in wall speakers and an aa001 integrated amplifier with a cheap Sony blue ray. More two box transparent power cords.a 32 in h sharp tv mounted on the wall I can watch a movie while relaxing in the jet tub.
Lol the garage system I have to get in from the farm a pair of beat klipsh Cornwall speakers and an old Kenwood integrated with a tube Sherwood tuner. That was a second hand store buy less than a hundred dollars on that one! Took about five years to find the pieces for it. Lol.
I will see if I can post a few pictures for you. Regards