TEAC NT-505 impossible connecting to WiFi router o such LAN: help me please?


Hello mates,
I got my NT-505 3 days ago.
It seems to be working correctly but in my opinion all software in not the same level than the device: too aged & often no relevant documentation or support about.
However my big trouble is the NETWORK interface:  since first time I switched on, the NT-505 remains "for ever"  into NET configuring blinking state until it goes in power stand by.
Summarizing:

1. RJ45 cable is ok - tested in several manners
2. the wifi router (1Gb fiber connection) is ok
3. the wifi router ether ports (4) are ok - I checked a bridged LAN configuration too

Testing the NT-505 Ether port It results:

1. the physical level of protocol seems working correctly just on-way: the interface recognizes correctly the bandwidth (Fast ot Giga in my case) end the packet coming from the router are buffered. No packet sent  to the router.

2. At protocol level no ARP session are involved hence impossible retrieve MAC address and trying to do something.


VERY STUPID ISSUES:

1. Being NET board logically split from MAIN board It's need a separate firmware(!!!): how can I upload the NET firmware if, as stated into documentation, I must use the mobile app and It's impossible connecting the device to such LAN?

2. NO menu interface to configure manually the net parameters.

May someone help me (tricks..., recovery sw,..., low level maintance menu...,...) 

Thank you a lot.


silvio66
Not sure what went wrong at first, but I can now switch music library easily in Lumin also.
This is one of the real major problems with the NT-505.  The owners manual really sucks big time.  So hard to really figure this thing out.  I spent an hour on the phone with an expert on this unit to figure out how to do just a couple of things I wanted to do.
Mine is still doing great after the repair. 
A lot of playing with the menu will help you figure this thing out. 
i haven't found it difficult to operate at all.  I have noticed that both the lumin and hr streamer app behave much better on an ipad v. samsung s20+.

I still haven't figured out how to incorporate the tunein radio function...
I still like mine so much that I’m now seriously considering going down the next rabbit hoe- the Teac cg-10m separate 20MHz clock - to take it even to the next level. 
18 months for me zero issues
@kren0006 My NT-505 has been perfect since I ran a CAT-8 cable to it.  I did not notice much if any difference adding the CG-10M.  You might be wasting your money.