What size countersunk screws for Audio Research Ref3


For top plate...

Anyone out there know?

Thanks in advance

ullogu1

If ARC doesn't pick up use the SAE since it's the states and most likely all will be well.

I would contact ARC.   See if they can send you some.  Countersunk screws have either 80° or 100° bevel.  A 100° bevel in a 80° will stick out and a 80° will not be flush in a 100° bevel.   Best to get the O.E.M. screws

My point was a quick phone call to ARC would probably get his answer.

I have all arc. A google search says the screws are 6-32.

Measure the diameter of the threads on the hole. They will fall into a range of the mating fit thread. Just do a quick google search and you will find it.

 

Screws are standards, ARC will not spec a special thread or diameter.

 

For example if the hole measures 0.189" then it is a 1/4in thread after that just need to determine if fine or coarse pitch