Duke and Buconero117,
Thanks for the references. Both of these will provide a lot of help.
Keithr,
Who is "Rives"?
Thanks for the references. Both of these will provide a lot of help.
Keithr,
Who is "Rives"?
Tips for designing listening room from scratch
Folks,
I am designing a listening and video room from scratch for a new house. General dimensions are approximately 11' wide by 20' long by 8' high rectangular room. This will be in the basement, so one wall and the floor will be concrete, at least to start. Length is the one variable that can be adjusted easily.
What tips can you offer as I design this room?
- electrical system, wires, outlets and breakers (house will have new electrical panel and wiring)
- flooring material (bare concrete, carpet, wood or laminate, cork, etc?)
- walls and ceiling (dry wall, bare concrete, wood paneling, other suggestions)
- soffits in ceiling - yes or no?
- book shelf along one long wall - OK?
- Door better at far end of wall away from front speakers?
- Speaker wire suggestions for in-wall installation for rear speakers (cost is an object - up to 30ft. runs)
- other ideas/suggestions welcome?
I am designing a listening and video room from scratch for a new house. General dimensions are approximately 11' wide by 20' long by 8' high rectangular room. This will be in the basement, so one wall and the floor will be concrete, at least to start. Length is the one variable that can be adjusted easily.
What tips can you offer as I design this room?
- electrical system, wires, outlets and breakers (house will have new electrical panel and wiring)
- flooring material (bare concrete, carpet, wood or laminate, cork, etc?)
- walls and ceiling (dry wall, bare concrete, wood paneling, other suggestions)
- soffits in ceiling - yes or no?
- book shelf along one long wall - OK?
- Door better at far end of wall away from front speakers?
- Speaker wire suggestions for in-wall installation for rear speakers (cost is an object - up to 30ft. runs)
- other ideas/suggestions welcome?
- ...
- 8 posts total
We had Chris Huston of rives custom design our Mastering and Post Production rooms in our basement. Granted they had 12' of ceiling heigth to work with. We built both using "room within room" method. We had Bob Hodas do the acoustical tuning afterwards. These are some of the best acoustics in the Pacific NW. Rives Audio Regards, |
- 8 posts total