Linn Majik speaker connection


I recently purchased a used Majik and am not quite sure how to terminate the amp end of the speaker cable. The manual says to use a "4mm plug". The Majik model I have apparently uses the older style speaker jack as it has no post in the middle, just an open hole.

Will a regular banana or BFA connector work?
e4mwc
Regular bananas will work, however the 4mm will give you a much better connection.
Cheers
Please excuse my ignorance Muzikat but 4mm as in a BFA connector or a 4mm connector made by Linn?
Best Regards
A LINN dealer can supply you with the needed terminations. They're not much and do provide a better connection than banannas. A point to note, if you ever go to a dedicated LINN amp, you will need different terminations again.
BTW- a big improvement in detail and dynamics can be had by using LINN std interconnect instead of the supplied jumpers for connecting the pre-out and amp section. I was originally using Tara jumpers, and then went to LINN i/c. Very pleasing improvement.