2. amps-preamps
  3. 1021779894

newbie need help on decision on buying an amp

first of all ,this is my first post and want to say hello to all the audigoner.. now here is the question..i am planning to buy a tube amplifier(KR anteras) .this amp produce around 20W which is very low for my Vandersteen 3A,to listen to my normal volume level.i have to turn it up to 4/5 of the maximum level.the question is..if i have to crank up the volume level so high..would it run short on the life of the amp? over work the amp?another word.i dont know if this the the right way to run the amp?please give me some advice because i dont know whether if i should buy this amp or not?. my pre-amp is the krell 250P..thanks in advance....
ttrhp
garfish
1,840 posts
 
Hi Tt; The Vand. 3As would benefit significantly from more power, especially in bass control-- they have 8 and 10" woofers. Look for a good McCormack DNA-0.5 or DNA-1 (or up-graded version) for a really synergistic combination and good power/bass control. The McCormack amps-- especially the Rev. B & A up-grades are very smooth, liquid and tube-like. If you're really into tubes though, something more powerful would still be desireable, IMO. Good Luck. Craig
sean
6,231 posts
 
Two situations can arise out of your question. Either your source component and preamp don't have enough output to really drive the KR or the KR is too small of an amp for what you want to do with your system.

If you've had the same sources and preamp with another amp, how far did you have to crank up the volume control and what type of amp was it ? If you were able to achieve good levels with the volume somewhere between 10 o'clock and 1 o'clock, that means that the problem is PROBABLY not in the sources or the preamp.

If the situation is the latter one, you are working the tubes to death. As such, i would NOT advise going this route since you'll be chewing up tubes on a rather fast basis. Sean
>
kt_88
242 posts
 
I'm not familiar with your amps, but I'm quite familiar with the Vandsersteen 3a's. They need more power period! Vandersteen audio suggests between 100-200 watts for this speaker. I have ran them with 60 watt tube amplifiers, but have found the bass to be a bit lacking. I have also owned a McCormack DNA-1 while it did drive the 3a's quite nicely, I didn't consider it liquid and tube sounding. But then how could it be? It is not a tube amp.

The Krell pre is a mismatch for a tube amp, I would think your ears got to be bleeding because of the harshness on the highs. It is not a good idea to have a solid state pre combined with a tube amp. If you insist on using solid state then you might try using a tube pre and a solid state amp. Personally I think everyone should run a tube pre and a tube amp.
natalie
404 posts
 
Go the Rogue route.
philefreak
423 posts
 
There is nothing wrong with Solid State pre. and tube amps. Just do your homework and match inpedance.
More to discover