Bass in my room isn't good? Help

Make sure that if you are sending a signal already crossed over from the Classe ssp25 that the sub is run at full frequency. It is common with home theater systems that this is misunderstood and the sub woofer is also set at the the same frequency. If you are already doing this then it is not adding to your problems. Good luck

Adding to Edle's to-the-point words, the 40Hz/ 160Hz "anomalies" could be due to speaker placement vs. room acoustics.

Is your JM the Mini Utopia? If so, roll-off should be sharp @ a little over 70Hz -- so play with the sub accordingly, as Edle suggests.

Good luck!

Two comments, the low frequency response you measured, while not excellent, is actually quite good. The two dips in response are not particularly serious and you have no real peaks. As a rule peaks are much more objectionable than dips in frequency response. You should play around with speaker placement to see if you could further smooth out the sound. Second, refer to the following: http://audiogo5.iserver.net/cgi-bin/fr.pl?htech&983682086&read&keyw&zzradio=shack, it gives the corrections for the Radio Shack meter.

EXCELLENT suggestions !!! I too think that the crossover needs fine tuning as there is not enough "blend" taking place between the two woofers.

I would also like to add that the drop at 160 hz could be due to floor bounce from the monitor. I am not familiar with these speakers or their size, so i don't know how high up on stands they are mounted. Adding a "speaker beard" below them might help to cure this, as it adds baffle area below the drivers. One would have to play with the length of the "beard" to fine tune the response accordingly.

Other than that, i would take the bass trap out of the room and then measure the response. Then try several different placements for the trap and compare readings. I would start off by walking around the room and see where you hear the muddiest / most bloated response and place the bass trap there, as that is where the strongest node is occuring. Sucking up the excess energy at that spot will PROBABLY do wonders in terms of "bass detail" in the rest of the room.

Overall, it appears that your problems are not nearly as severe as others might be dealing with and mostly correctable with some fine tuning. Good luck and keep us posted.

Hi,
Thanks for your responds. Here are more of information.
My stereo system is on second floor and don't have any spikes yet. Room size L=14.8'X W=12'X H=8'. The Jmlab monitor Electra 905 goes down 57Hz with -/+3db. The Classe SSP25 has only one crossover frequency 80db, and I set the sub at 85db. The vollum on the sub is about 1/4 of the max.
I set the speakers 5'from the wall behind it, and 3'from the side wall for the last measurement. I changed the speakers 3' from the wall behind it, 2.5' from the side wall this morning.
1k=79; 200=76; 160=74; 125=78.5; 100=75; 80=78.5; 63=69.5
50=67.5; 40=78; 31.5=75
Look like everything are almost the same except for 160Hz improving a bit and 63, and 50Hz get worst.
One more question, if I measure from 30Hz to 20Khz, what should I expect the grap look like? How many db difference between the peak to valley is acceptable?
Thank you very much
DT