Room treatment


I'm facing the reality now that I need to treat my listening room acousticly. I've had my system in the basement for at least a year now with concrete on three sides and one sidewall with wood paneling. The ceiling is tongue-and-groove. The room is about 12'x 20'.

Acording to my research, 50% of SQ is the room, costs of $4000-$5000 are common, and most audiophiles will spend those g's on gear before they will spend them on room treatment. Only one or two companies make foam that is actually effective since other inexpensive foams like egg carton foam are not dense enough.

It is possible to make low cost acoustic panels with Corning fiberglass blankets framed in 2 x 4's and covered with fabric, and one critic who hired an expert to treat his room shows a pic his ceiling hung with these panels in a pattern.

I am willing to make these fiberglass insulation panels but I want to run this info by the members first. Am I missing something or are my choices limited to either these low cost panels or the 5g treatment?

arnettpartners
You can spend a lot of time and money chasing room acoustics. Some go overboard with acoustic panels and end up with a room that sounds dead. Usually corner bass traps can help and treating the first reflection points with diffusion or fiberglass panels is money well spent. The rear wall can benefit from some diffusers. Go slow and bring in a modest amount of treatment at a time to determine if it makes a positive impact.
Upper and lower room corners are quite problematic since they produce very high sound pressures, actually much higher than the average sound pressure in the room when music is playing.
Upper and lower room corners are quite problematic since they produce very high sound pressures, actually much higher than the average sound pressure in the room when music is playing.
Geoffkait

Don't sit with your head in the corner. Problem solved. ;)

Seriously though, another nod to ATS Acoustics. Well built, fairly priced and quick. I built a couple DIY pieces with ok results. After purchasing a couple panels from ATS, I won't build any more. By the time you run around getting supplies, building and cleaning up, it seemed more cost effective to buy ready made pieces. And they looked better too.
OK. 1 x 3 instead of 2 x 4; ductboard or other materials, thicker and/or denser material for bass traps, all corners, wave the ceiling, go slowly so it doesn't get too dead, keep head out of corner.

I think I've got it.

Thanks, everybody for great info.

Lynne