Digital Amplifier Questions

In my system pic, you will notice that I do keep my amps on their own stand physically separated from other line level gear to help insure against noise. Can only help and not hurt. One can always experiment either way to see if it makes a difference. I also keep some space between amps as additional physical isolation between the two.

ALso not that it seems there have been strides made with newer Class D amps in regards to noise levels. Mine are a generation old and are quieter than what proceeded them. The latest and greatest are likely even better in taht regard, but of course every product is different. Its just worth noting that these things can produce a fair amount of RF noise if not addressed in the design.

Also not that Class D amps are switching amps, not digital, however both use very high frequency oscillators that produce RF noise and that must be controlled, either by design or otherwise. Most modern devices like Class D amps and computers that can suffer from noise issues designed for hifi audio use tend to have these things largely in control due to their potential negative effects on sound quality but just be aware that it can be a real issue that can limit performance if not under control somehow.

Once is enough!!

B limo,

By 'digital amps' do you mean class d amps? 'digital amps' is a bit of a misnomer probably persisting because people believe 'class d' refers to digital, but it was just the next letter in the alphabet used to designate various types of audio amplifiers using different methods of amplification. Class A defines amplifiers that use a more traditional circuit that has input devices that constantly remain 'on', resulting in excellent sound but produce excessive heat as a byproduct. Class D amps use 'switch mode power supplies' (smps) that are able to switch on and off extremely quickly, which produces much less wasted heat as a byproduct. I use a pair of class d mono-blocks that sound very good, output over 1k watts and barely get warm to the touch no matter how hard they're driven. I leave them on 24/7 since they only require a few watts of electricity at idle.

I'm no expert on amplifier design, so others may need to answer your other questions. So, if by 'digital' you meant class d, then yes I would advise to leave them on constantly. I thought it would be useful to clarify your question before your thread progresses.

Let us know,
Tim

I prefer Class D left disconnected at all times.

I mean class d, which I thought was some type of digital amp...I just briefly read about that lastnight. I'm going to go read up for a minute and see if I can get this...