Bi Amp JM Lab 936's

You need to experiment and determine what sounds the best. Really depends on the amp, cables, and how the overall sonics sound from the 936s.

When in mono what didn't you like about the sound?

Did you use jumpers on the amps and 936's?

Bi-wire. If done properly it is more beneficial than bi-amping. The best way to bi-wire is with separate wires (not bundled with bi-wire tails). I have 8 wires connecting the speakers.

You can setup for Bi-wiring using Jumpers and speaker cables.

Use a Jumper on speakers top terminal connected to the high frequency section and the bottom terminal connected to the bass section.

Take the speaker cable and connect positive side (via banana)to the high frequency section and the negative side (via banana) connected to the bass section.

Do NOT use jumpers and do NOT use bananas. Both ruin the sound. If you do not follow my suggestion for bi-wiring, there will be no benefit. You must have seperate wires for it to work properly. For a thorough explanation go to Vandersteen.com. Richard explains it there.

>>Bi-wire. If done properly it is more beneficial than bi-amping.<<

That is completely untrue and demonstrates a complete misunderstanding of bi-amping and bi-wiring.

It depends on the speaker.

Check with the manufacturer and/or retailer for a recommendation.