Bi Amp JM Lab 936's

You can setup for Bi-wiring using Jumpers and speaker cables.

Use a Jumper on speakers top terminal connected to the high frequency section and the bottom terminal connected to the bass section.

Take the speaker cable and connect positive side (via banana)to the high frequency section and the negative side (via banana) connected to the bass section.

Do NOT use jumpers and do NOT use bananas. Both ruin the sound. If you do not follow my suggestion for bi-wiring, there will be no benefit. You must have seperate wires for it to work properly. For a thorough explanation go to Vandersteen.com. Richard explains it there.

>>Bi-wire. If done properly it is more beneficial than bi-amping.<<

That is completely untrue and demonstrates a complete misunderstanding of bi-amping and bi-wiring.

It depends on the speaker.

Check with the manufacturer and/or retailer for a recommendation.

>>Do NOT use jumpers and do NOT use bananas<<

This is also an erroneous statement. In many cases bananas are preferred as the termination of choice.

There is some very bad information contained in this thread.

Undoubtedly a result of inexperience. Ignore it.

Hello i owned the same model 936...remember this speaker is efficient.I paired this with 2 mc-225 (tube) at mono ( 50 watts )and result are excellent..sometimes driven by a single mc-2100 (s/s)..same ..very musical.
I do bi-amping by using a single mc-225 on stereo to drive the hf/mf and mc-2100 (s/s) to drive the lower part and the result very musical and detailed of course paired with Cary SLP-98 tube pre-amp.
Buck44,single amp will do the job and can drive your 936 at no ease.
Recommendation:
Single amp.......5 *****
bi-amp...........5 *****+ headroom & dynamic range.
Enjoy your music.