Which wood and design for diy monitor stands?

If I was using wood, I would build it as a box, close to the width x depth of the speaker base so it could be filled with sand or shot. A good 3/4" cabinet grade plywood or mdf would be my choice. It is more stable than 3/4" board stock, less likely to warp or check and the surfaces finish evenly. I would then get a set of feet that would support the weight of the speaker, available at all the parts stores.

I built a pair of stands modeled on the Skylan stands. I used Ipe, which is a Brazilian hardwood I believe, but it is the hardest, heaviest wood I have ever seen. You can't nail through it, and you have to drill your pilot holes for the screws the exact same size as the screw, or the screw will break off. I used 1" mahogany for the top and bottom panels, glued and screwed to the Ipe 4x4's. I then mounted spikes on the top and the bottom. You can see a picture in my system profile.

Hanaleimike,

those are really beautiful stands. So you decided to use posts that attach to planks on each end. Do you think that it would sound better if the wood was solid the whole way up?

Zenblaster,

I have a friend who is a pro cabinet maker who is going to make these for me and a major reason is WAF. So I want to stay away from the box look.

thanks
andy

Hanalemike - Nice stands. I've used Ipe (also known as Ironwood) quite extensively in various outdoor projects (outdoor railings and bridge decking). I think most of the Ipe you buy these days is coming from Mexico. Good warnings you've already provided - be prepared to pre-drill everything for the thread, shank and head of screws, or screws will certainly snap right off. I opt to use three separate bits for that as the various countersink bits I've tried burnout in Ipe too fast. Also, very important if you choose to work with that wood - the ultra-fine sawdust it produces can be both irritating to skin and eyes, and is supposed to be carcinogenic - definitely wear a good dust mask and eye protection, work outdoors whenever possible, and clean up thoroughly afterwards. I always wondered about using this wood for vibration and wondered if it would be appropriate. It is remarkably dense and heavy. It is used frequently for outdoor decking and projects that will be similarly exposed. The outdoor lifespan of untreated Ipe is around 90 years! It is also naturally resistant to rot and insects. Not very relevant to use as an audio platform. I wonder why it it is not used more frequently in audio applications. I'd guess the weight of a similarly sized piece of Maple, for instance, would be about 2/3 that of Ipe. It is a bitch to work with though, and that may be why you don't see it that often in indoor projects. It's also not very pretty as wood goes, being rather dull and without much visual depth to the surface. I wonder if, when you get into woods of this density could they be counter to the reasons for using wood in the first place (does Ipe "sound good" as a platform, or does it move into the direction of a marble platform - so rigid that it actually may amplify vibration?).

I don't know which look better, the Spendor's or the stands they are sitting on.

As for the wood being solid all the way up I can't say, but FWIW, using a hollow center post allows you to fill it with some materials that could provide better mass and dampening properties. Kitty litter, fine sand, #8 lead shot, or Star Sound Technology Micro Bearing fill are good candidates. My stands have a combination of kitty litter and lead shot in them.