Laser recommendation for Spkr set-up?


Curious what you guys are using to set-up your speakers other than a measuring tape, square and tape and any particular brand that works best?

thanks
128x128wig
Guys,

Thanks for the advice! It will help in getting things dialed in quickly and possibly more accurately. Typically, I take four measurements out from the front wall and lay painters tape across those four points about 10' in length as a starting point.

Off to Home Depot to pick up one and to study how to use it before I add Stillpoints Ultra SS under my speakers...
Wig, I have the Bosch and it works well and is accurate. Less time consuming than a tape measure.
Boys and Girls...this is not the way to use a laser to set up the speaker. You don't want to point the laser at the listening position. Here's how to do it:

First use a level and level your speakers. Turn your laser on and put it on top of one of the speakers. Get a postit (those yellow stickums) and place one of these at the back wall of your listening room, centered between the speakers. Slowly rotate the laser (the red dot will move on your back wall - behind your listening position. Make sure you keep the laser flat against the top of your speaker. Put a dot where the laser strikes the postit. You may have to raise or lower the postit to accomodate the laser dot. Put the laser on the other speaker and again swing the dot left/right, until it aligns with the black dot on the postit. If it doesn't align, you have to raise or lower the angle of one of the speakers. You will be amazed at the solid image your speakers are now able to provide. Enjoy.
"09-13-15: Wig
Just ordered one any tips on using it?"

I don't know if this matters to you or not, but the Bosh I have only does feet. No inches. If you need to measure in inches, you have to manually convert. Metric doesn't have this problem. Also, I don't know Bosh does it this way with all their models, or just mine. I'm pretty sure Makita's do inches, but I think they cost a little more.