Synergistic Red Fuse ...

If you confirmed the correct fuse type and value with the device maker and bought that fuse from a fuse dealer,   and the fuse blows,  I do not think you have any recourse with the fuse dealer if they choose to not replace it.

The reason is that these are fuses.  Fuses are SAFETY AND PROTECTION DEVICES.   You have to be prepared to replace one when it blows for any reason.   It goes with the turf in the case of fuses.

Yes, fuse dealer makes a hefty profit likely and could afford to replace a blown fuse here and there but no fuse dealer is obligated to replace a fuse if it blows.   Its what fuses do!!!!!

So if one is not happy I'd say find another fuse dealer whose properly spec'ed fuses do not blow when it seems they should not.

The cost of replacing expensive fuses when they blow is a topic worth some discussion I think.   Its a normal thing to expect that some fuses will blow over time for whatever reason and have to be replaced.    You might find a nice fancy fuse dealer willing to replace some to some extent but its not reasonable I would say to expect that.

If the cost of replacing blown expensive fuses becomes a problem for anyone, then I'd say you need to find an alternative.  There are many high quality commercial fuses out there for not very much certainly in comparison.  That's why 99.999999999% of the world does not use high priced fuses.

If the sound quality benefits justify the normal total cost of ownership of expensive fuses over time, then no problem.  Its the typical high end audiophile dilemma,   optimize sound quality for higher cost or not.

It would seem to me that if there is any question regarding the current rating of a fuse, a maker would lean in the direction of safety and have the fuse blow sooner rather than later. Sooner is safer. Later is riskier.

If fuse does not blow and equipment gets damaged, then the maker has a potential legal and liability problem.

if fuse blows sooner than perhaps it should, then not only is that safer and normal for a fuse but fuse must be replaced meaning more sales and revenue.

Sound like a nice business to be in as long as one plays it safe....

joncourage ...

I agree with sgordon1 ... call SR in California and see if they can help you out. You are the first one to have reported a problem. I've done business with highend-audio with no problems at all. They happily took my last two SR Red fuses back in exchange for two SR Black fuses with me paying the addition cost of the Black fuses. No questions asked. 

Keep in mind that now that you've reported a problem on this thread, which was the correct thing to do, you are somewhat obligated to follow up with the rest of us as to your results in getting it resolved. Hopefully, you'll have some positive results to report. 

As mapman said though ... there is no obligation for anyone to make a blown fuse good. 

Good luck ...

Sorry, I meant to say highend-electronics. Bah on me. 

I have found that the Synergistic fuses to be quite touchy and will blow quicker than many other fuses of the same value. I was told that they are held to a more exact value than others. In fact AA advised me to get a slightly larger value when using Synergistic fuses.