Look for an Audio Research 100.2. It's one of their best solid state amps. I used to own one and it's an incredible amp. Nothing touches it for the money.
solid state amp power
Currently I have an LFD Mark IV (60 watts) driving a pair of Harbeth C7ES-3. I've caught upgrade-itis. I'm thinking about going to the Super HL5-Plus and if I do that I'm going to replace my whole system. The reason being that I want to use a PS Audio Direct Stream DAC as the source, in which case I no longer need an integrated amp. I want to try running the DAC directly to an amp. My question is then, which amp to get?
I want to use a solid state amp but I'm finding it diffictult to find an interesting amp that is not integrated and produces less than 100 WPC. Additionally, I don't want an amp that runs hot at idle. Currently I never turn my LFD over 30% volume unless I'm listening to it from the next room so, even 60 WPC is far more than I need.
If I can't find an amp I like under 100 WPC, I may try the Classé CA-D200, which is 200 WPC. Is this powerful amp going to be too loud for me at even the lowest settings?
Any advice is welcome.
I want to use a solid state amp but I'm finding it diffictult to find an interesting amp that is not integrated and produces less than 100 WPC. Additionally, I don't want an amp that runs hot at idle. Currently I never turn my LFD over 30% volume unless I'm listening to it from the next room so, even 60 WPC is far more than I need.
If I can't find an amp I like under 100 WPC, I may try the Classé CA-D200, which is 200 WPC. Is this powerful amp going to be too loud for me at even the lowest settings?
Any advice is welcome.
- ...
- 14 posts total
I would be more concerned about the nature of the gain provided by the Direct Stream DAC than the wattage of the amplifier. I would think one would want to drive an amp using 30- 70% range on volume control of the DS DAC. Other may chime in on my thinking on this. I think that by considering 50-100wpc amplifiers one opens up far greater possibilities. That wattage would not be over-kill for your speakers. |
I run a DAC directly into my gorgeous sounding 30 wpc Pass XA30.5. Probably one of the of the top 2-3 in the under 100 wpc category. These show up frequently on the used market. The newer replacement model is the XA30.8. About $6000. They run warm, but not hot, at idle. In standby mode they are cold. |
I purchased the Hypex NCore NC400 Bridged Mono Block class D Power Amplifiers ($2,980) from James Romeyn Music and Audio, LLC (James). He was very helpful answering my many questions and I suggest you contact him for more information on his custom assembled Hypex NCore power amplifiers (he offers 3 models). This is my first class D power amplifier and, based on my results, sounds terrific. Of course, everyone has a different opinion on this subject. You never know “how it really sounds”, until you listen in your room and system. Specs are 200/400/600Wpc @ 8/4/2 Ohms, 1 Ohm minimum, mono w/SMPS600 or stereo w/SMPS1200A400. Draws about 4W @ idle per NC400. Bridged mono bloc 400/800/1200W @ 8/4/2 Ohms, 1 Ohm minimum. These power amplifiers are capable of driving any speaker and do not get hot. I am thrilled with how good my system sounds since I am hearing details, imaging and bass that I have not heard before. I highly recommend you contact James for information on his Hypex NCore power amplifiers. My speakers are the Sonus Faber Olympica II Speakers. http://jamesromeyn.com/old-pages/home-audio-gear/hypex-ncore-nc400-build-service-on-time-or-free-bui... |
- 14 posts total