2. analog
  3. 127059-527

Downsizing from VPI HW-19

Hey all,

I've been a more-or-less happy owner of a VPI HW-19 Mk.4 for the past few years, but I've found I'm more of a vinyl appreciator than a devotee. That said, I do ferret out the best pressings on discogs and other venues of certain lp's I want, and my VPI (with Benz Ace S cartridge) DOES produce a hauntingly beautiful sound through the Jolida JD9 Mk. 2 phono than my Rotel 1072 does through the Jolida FX DAC. But I feel I'm constantly fussing with VTF, azimuth, and the need to level the three-screw platter of the HW-19. I even bought a dial indicator and clamp and still have a devil of a time. I finally took out the three screws. But now am paranoid about a difference in sound.

In short, I find I'm listening to the vinyl system rather than the vinyl music.

I'm not really a mechanical guy. I mean, I'm happy soldering new tweeters into speakers, but I know I've already screwed up the SAMA by letting it contact the plinth when it shouldn't have. The sound's not affected, but I'm going to have to solder a new bearing motor into the SAMA.

What's a good downsize? I originally had a Project 5.1 SE with a Sumiko Blue Point before I acquired the VPI. But the VPI/Benz sound is beautiful and what I want, though. How can I downsize to a less demanding table and still have a warm and palpable sound?

Thank you for any and all feedback. Please be gentle.

s
128x128simao
simao's avatar
simao OP
1,836 posts
 
Like all machines, this one may need servicing, too. I really do appreciate all your advice and cautions. I don't need to tell you that the sound and immersion I get from vinyl is so enveloping, so palpable. And I don't want to lose that. But I also don't want to spend every listening session listening to the equipment, either.

@terry9  By thin record, you're talking 150g or less, right?

s
terry9
2,354 posts
 
Sim, I just mean the thinnest which you play. I play all the way from about 80g up - some of those old editions are mighty flimsy.

bpoletti
1,554 posts
 
simao - There's no real learning curve on a -19 Mk IV.  But the springs must be replaced with pucks and the cartridge carefully aligned.  Fremer has an OK description of cartridge set-up.  VTF, once set, shouldn't need to be reset unless there are problems with the arm / counterweight.  

What is your location?  Maybe you could get help from a forum member or two.
bruceofcleveland
7 posts
 
Here's what I did (flamesuit on) ... same table, 12.5 Memorial arm, etc. ... got tired of the urge to tweak and play, and removed everything except the motor ... bask in simplicity ... move motor over, and connect motor to platter via dental floss ... enjoy. Okay, we also measured the heck out of everything along the way and discovered it's actually a teeny bit quieter. All due, I believe, to eliminating all the extra spinning things and belts...Oh, and those bladder things, etc., toss them out and go, like VPI did, to handballs. Seriously, VPI used handballs. Or was it squash balls?
mb1audio
151 posts
 
Here's an article on TT setup. The person who wrote it was considered to be one of the very best in the industry.

http://brooksberdanltd.com/turntable-setup-by-richard-hardesty
More to discover