2. speakers
  3. 129881-63615

Speaker match for PrimaLuna Dialogue Premium HP Integrated?

Hey Guys,
Wondering about speaker match for PrimaLuna Dialogue Premium HP Integrated.
Using KT150 and Mullard CV4003. So maybe 50 watts in triode and 100 watts in ultralinear.
Don't like ultralinear much. (GeorgeHiFi linked some curves showing ringing in ultralinear:
https://forum.audiogon.com/discussions/primaluna-dialogue-premium-hp-tube-rolling-suggestions-to-red...)
Setup is in a small room currently. Had used Revel F206 (which I still have) and now Zu Druid MK IV.
Revels sound pretty good but I don't think they show their best with limited tube power.
Plenty of power for the Druid, and it sounds pretty good but response curve seems uneven to me.
So Revel nice response curve but a little tame. Druid pretty lively/ fun but uneven tonal balance.
Anyone have a particular favorite speaker match up for that amp in the $3K-$5K range?

leotis
smrex13
645 posts
 
Actually, I think we're confusing two different models with the measurements on the ringing.  If I'm not mistaken, the Stereophile measurements cited in the previous post were taken with the Dialogue Premium Amp, not the "HP" version and not the integrated.  

The Premium HP integrated was also reviewed by Stereophile, and it was given a pretty clean bill of health.  JA says it measured well for a P/P amp using EL34s.  That's not to say that you don't hear brightness, but it might be elsewhere in the system if you have the Integrated HP.

Best, Scott
aniwolfe
760 posts
 
@georgehifi 

George lets get this right. What are the graphs for the integrated amps? Thanks
georgehifi's avatar
georgehifi
10,312 posts
 
I didn't post any here, they are on another thread. And John Alexander backs it in his measurement conclusion.
https://forum.audiogon.com/posts/1425159

Cheers George

 
fritzspeaks
44 posts
 
You may want to take a look at my FritzSpeakers Carbon 7SE model which are below your budget.  With the smooth series crossovers they are very easy to drive even with low powered tube amps.  Conventional crossover impedance curves usually look like a mountain range with large peaks and valleys.  With a tube amp, this will result in an uneven frequency response with bumps and suck-outs due to the fact that tube amps will deliver more power to the frequencies with the higher impedance peaks.

http://fritzspeakers.com/Images/speakers/Carbon7SEimpedancePhaseGraph900.jpg

fritzspeakers.com/DreamWeaverFritzImpedancePage.asp

Disclaimer- I'm Fritz, the builder of FritzSpeakers
aniwolfe
760 posts
 
@georgehifi 

Which link is for the Integrated Amp?
You know that we are not talking about the Power Amp on this thread?
More to discover