Looking for a solid state preamp for Krell fpb 250m monoblocks

Sorry, I mentioned 300m which is incorrect. I have 250m monoblocks. I have just this minute completed the task of removing two small black plastic jumpers , which then engages the capacitors into the signal path, and makes the tube preamp safe for operation with the Krell solid state monos.  Patrick at Krell gave me a little diagram and specific instructions for performing the operation.
It takes a lot longer to remove the screws (8 on each mono) and take off the covers then it does to make the adjustment by removing the little plastic jumpers. Then I put back all 16 screws and now I'm good to go! I will soon see how the Transcendent tube preamp performs with the Krell. 

Michael,

Which preamp did you decide to go with your Krell 250M monoblocs and how does it sound?

Gary

WOW Michael, been there done that!

Years ago I used a Krell FPB 200 stereo amp with Thiel CS6's.  I went through a bunch of amps and pre-amps, tube and SS.  With my gear the Thiels were bright and could get down right tinny at times.  Tubes took some of the brightness away.  If I had to do it again I would stay away from tube pre's with 6SN7 tubes and stay with 12AX7 (the best) or 12AT7 and 12AU7's. 

I never got my Thiel's dialed in to my liking and now use B&W 801s3's.  Yet, I still have the 6's and use them a few days, every year or so. 

I can't say how it would work with your equipment but I recently purchased a Mcintosh C2500 pre-amp.  It is the best tube pre I've ever used.  To my ears, it is warm and smooth.  Also it reacts nicely to tube rolling.

Good Luck.

SS.... So,  The Klyne is a wonderful suggestion.
SST Ambrosia
Jeff Rowland Capri S2
Coda 07X 

These 4 are all hard core solid state performers.